Getting Started Guide

ManualsBrandsNUU ManualsCell PhonesLTE Smart phone

FCC Information

FCC STATEMENT

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that

may cause undesired operation.

2. Changes or modiﬁcations not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

SAR Information Statement

Your wireless phone is a radio transmitter and receiver. It is designed and manufactured

not to exceed the emission limits for exposure to radiofrequency (RF) energy set by

the Federal Communications Commission of the U.S. Government. These limits are

part of comprehensive guidelines and establish permitted levels of RF energy for the

general population. The guidelines are based on standards that were developed

by independent scientiﬁc organizations through periodic and thorough evaluation

of scientiﬁc studies. The standards include a substantial safety margin designed to

assure the safety of all persons, regardless of age and health. The exposure standard

for wireless mobile phones employs a unit of measurement known as the Speciﬁc

Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. * Tests for SAR are

conducted with the phone transmitting at its highest certiﬁed power level in all tested

frequency bands. Although the SAR is determined at the highest certiﬁed power level,

the actual SAR level of the phone while operating can be well below the maximum

value. This is because the phone is designed to operate at multiple power levels so

as to use only the power required to reach the network. In general, the closer you

are to a wireless base station antenna, the lower the power output. Before a phone

model is available for sale to the public, it must be tested and certiﬁed to the FCC that

it does not exceed the limit established by the government adopted requirement for

safe exposure. The tests are performed in positions and locations (e.g., at the ear and

worn on the body) as required by the FCC for each model. The highest SAR value for

this model phone when tested for use at the ear is 0.295W/Kg and when worn on the

body, as described in this user guide, is 1.192W/Kg(Body-worn measurements differ

among phone models, depending upon available accessories and FCC requirements).

只供FCC認証使用