Crystal Titan Series Supported Cameras

Copyright © 2014 NUUO Inc. All rights reserved.
www.nuuo.com
1
NVRsolo Supported Camera List
DP v3.3_release date 2014.5
1 / 1
Device
Name
Tested
Firmware
Video
Format
Video
Ch
Max
Resolution
Audio
I/O
Ch
PTZ
On-Edge
Motion
UPnP
Multi Stream
Support
Remarks
Generic
z120130417
NSA
H.264
M-JPEG
1 2592x1944 1-way 4/2 Yes Yes - Yes
Note:
na063
z120120523
NSA
H.264 1 2592x1944 1-way 1/1 - Yes Yes Yes
Note:
NA083
z120131016
NSA
H.264
M-JPEG
1 2592x1944 1-way 1/1 - Yes Yes Yes
Note:
NH061-CCD
CCD-
cameraFw-
100205P
H.264
MPEG4
M-JPEG
1 1280x960 1-way 1/1 - Yes Yes Yes
Note:
NH221-CCD
CCD-
cameraFw-
100205P
H.264
MPEG4
M-JPEG
1 1280x960 1-way 1/1 - Yes Yes Yes
Note:
NH720-
20N1
pm20120222
NSA
MJPEG/H
264
1 1920x1080 1-way 4/2 - Yes Yes Yes
NH720-
20N8
Refer to
NH820-20N8
(z120131126
MJPEG/H
264
1 1920x1080 1-way 4/2 Yes Yes Yes Yes
NH820-
20N1
pm20120222
NSA
MJPEG/H
264
1 1920x1080 1-way 4/2 Yes Yes Yes Yes
NH820-
20N8
z120131126
NSA
MJPEG/H
264
1 1920x1080 1-way 4/2 Yes Yes Yes Yes
nv053
pm20120222
NSA
MJPEG/H
264
1 1920x1080 1-way 1/1 Yes Yes Yes Yes
DYNACOLOR
- : not avaliable on camera
*1: not avaliable on software
*2: not test on software
For multi stream support:
Yes: multi stream fix to 500kbps/100kbps
Yes*: multi stream setting support
Camera FW is not stable enough, so camera is likely disconnected after modifying parameters. Current workaround is
turning off and on to reboot camera.
Remove resolution 1280x720 in H.264 codec due to broken image problem.
Known FW issue: audio may be broken in certain operation.
Remove resolution 1280x720 in H.264 codec due to broken image problem.
The image is broken badly when configuring to the highest resolution, fps, and quality under H.264/MPEG4 with UDP
protocol.
Known FW issue: audio may be broken in certain operation.
1. Video parameter can't sync with camera web interface, need to refresh the browser
2. Talk quality is not clear
3. Camera doesn't tranport sufficient framerate when stream parameter set to high resolution & quality, and camera's
resonse will become slowly.
Generic support model: W1-BA100, W2-BAZ40, W5-CDWK0, NH073, NH063
Parameter setting will fail when mutistream is allow and resolution higher than 1080p.
PT function are not test on software.
The maximum resolution is depends on camera.
Camera firmwave must be z120130417NSA or above then can use generic model.
1. M-JPEG on high resolution and quality may not get parameter.
2. Audio has some noise in high resolution.