Programming Manual
Algovita Spinal Cord Stimulation System
Clinician Programming Manual
23
6. Conguring Stimulators and Leads
When you create a patient, the Clinician Programmer prompts you to add a stimulator. For a patient already assigned a
stimulator, you can access information about stimulators and leads through the Navigation menu.
Adding a Stimulator
To add a stimulator:
1. Select Stimulator from the Navigation menu.
2. Tap Scan.
e Clinician Programmer scans for stimulators within range.
3. Tap the triangles on either side of the stimular to view the stimulators within range.
4. Tap the stimulator that matches the patient’s stimulator.
e trial simulator serial number is on the label on the back of the stimulator. e implantable stimulator packaging
material and the front of the implantable stimulator includes the serial number.
Note: If a stimulator does not display in the list, make sure it is on, nearby, suciently charged, and not connected
to another Clinician Programmer, Programmer Charger, or Pocket Programmer by turning the programmers o or
moving them out of range.
0300-000176-001 Rev.2 SCS CP_Mobile.indb 23 7/12/19 9:20 AM