Installation Guide

Installation Instruction

Peel-n-Stick

03/07/2017 Page 1

ATTENTION! INSPECT ALL MATERIALS CAREFULLY BEFORE INSTALLATION; WARRANTIES DO NOT COVER

MATERIALS WITH VISIBLE DEFECTS ONCE THEY ARE INSTALLED.

Expect the Natural Variation of Wood

All our wall products are designed to highlight the natural variation of wood and will feature mineral streaks,

closed knots, heartwood, smooth and textured surfaces. Each wood piece has been individual Kiln dried to ensure

consistency of the final product visual.

CAUTION: WOOD DUST

Cutting, sanding or machining wood products produces wood dust. While wood products are not hazardous under

OSHA Hazard Communication Standard (29CFR 1910.1200), the International Agency for Research on Cancer

(IARC) and the State of California has classified wood dust as a human carcinogen. PROPOSITION 65 WARNING:

This product produces wood dust when cut, sanded or machined. Wood dust is considered a carcinogen by the

State of California.

Precautionary Measures: Airborne wood dust can cause respiratory, skin and eye irritation. Power tools should be

equipped with a dust collector. Use an appropriate NIOSH-designated dust mask. Avoid dust contact with skin and

eyes. First Aid Measures in case of irritations: In case of irritation flush eyes with water. If needed seek medical

attention. If dermatitis occurs, seek medical attention

IMPORTANT:

Read the following instructions in there entirety before opening any packaging or starting

installation

DO NOT INSTALL FOR USE AS A FLOOR

FOR INTERIOR USE, ONLY RESIDENTIAL OR COMMERCIAL

VERTICAL OR HORIZONTAL INSTALLATION DIRECTION

 Installation at any other angle is also acceptable although more waste is created.

SEASONAL CHANGES

 Seasonal gapping should be expected and does not constitute a product failure.

 It is normal that natural wood will be affected by fluctuating levels of humidity within the installed area.

 Care should be taken to control humidity levels to within the 35-55% range and temperatures of 65°-75° F, to

minimize natural expansion and contraction.

 Product is best installed at room temperature 65°-75° F.

NATURAL COLOR CHANGES AND VARIATION

 Expect color changes in natural products. Sunlight or intense artificial lighting can cause color changes in the

finished product (Oxidation). Window treatments will usually provide adequate protection and reduce the

oxidation process.

 Wood is a natural material and variations in color, knots, and mineral lines are to be expected.

 When installing, mix planks from 3-4 cartons at a time to ensure a good blend of the natural variation.

PAGE 1
Installation Instruction Peel-n-Stick ATTENTION! INSPECT ALL MATERIALS CAREFULLY BEFORE INSTALLATION; WARRANTIES DO NOT COVER MATERIALS WITH VISIBLE DEFECTS ONCE THEY ARE INSTALLED. Expect the Natural Variation of Wood All our wall products are designed to highlight the natural variation of wood and will feature mineral streaks, closed knots, heartwood, smooth and textured surfaces. Each wood piece has been individual Kiln dried to ensure consistency of the final product visual.
PAGE 2
Installation Instruction Peel-n-Stick INSTALLATION PROCEDURE  THE SURFACE MUSE BE CLEAN, DRY, AND STRUCTURALLY SOUND. IF WALL IS TEXTURED, SMOOTH IT BY SANDING.  THE SURFACE MUST BE FLAT WITHIN ½” OVER 48”  AVOID WALLS WITH EXCESSIVE DEFLECTION. INDICATIONS OF EXCESS DEFLECTION ARE CONCAVE OR CONVEX MOVEMENT.