Operation Manual

15
EN
TECHNICAL OWNER MANUAL
6.5 Installing the Hub Encoder
(Older Harmony Systems)
Older “chain only” Harmony systems require
a color-matched hub encoder (A) that must be
secured over the CVP cover. Six magnets in
the hub encoder provide bicycle speed for the
Harmony system.
Belt-compatible Harmony systems do
not utilize the output speed encoder,
but rather utilize an output speed
ring. If you are unsure of which system the
bicycle came installed with, see section 8.5.
1. Prior to installing the sprocket, align the
hub encoder over the right hand side of
the CVP.
• Assemble with the hub encoder magnets
facing the CVP.
• Align the key on the CVP r.h. shield (B)
with the keyway (C) on the hub encoder, as
shown.
2. Install the hub encoder by starting at the
key location and pressing the hub encoder
onto the r.h. shield.
• “Walk” the snap-fit around to the opposite
side of the key location with continuous
pressure.
• The hub encoder should be tight and
secure, flush to the CVP (D), as shown.
HARMONY ASSEMBLY OF COMPONENTS
D
C
B
A

!