Installation Guide

Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
Step 8:
Bolt two nuts (7) onto hinge bolt (4) with tension plate (6) between them.
Place post collar (3) on main post and fasten assembled hinge bolt from step #1 with a nut (7).
Assemble bottom frame collar (1) on gate frame with nuts and bolts (2) and place on hinge bolt (4).
Place spring (5) on hinge bolt (4) and set bottom spring prong through hole in spring tension
plate (6) and behind post; and set top spring prong in front of gate frame.
Assemble top frame collar (1) on gate frame with nuts and bolts (2) and place on hinge bolt (4).
Adjust the spring tension by moving spring tension plate (6).
Align gate and tighten all nuts and bolts.
Install 1” Finial inserts on top of the gate frame if applicable (Diamond & Sapphire styles only).
PARTS:
DOUBLE SWING GATE
1.
2.
3.
4.
5.
6.
7.
2-Piece Frame Collar
Nuts and Bolts for Frame Collar
2-Piece Post Collar
Hinge Bolt
Spring - used for spring closure
application
Spring Tension Plate - used for
spring closure application
Nuts for Hinge Bolt
NUVO IRON
TM
, 3 Holland Drive, Bolton, Ontario, Canada L7E 1G7 1-866-955-0355 www.nuvoiron.com
GATE HARDWARE ASSEMBLY INSTRUCTIONS FOR
SPRING CLOSURE / REGULAR GATE HARDWARE
Nuvo Iron
TM
, its advertising agency and delegates have made every eort to ensure the accuracy of all measurements and other details in these instructions and we anticipate
no problems to arise. However, we cannot be responsible for errors beyond that eort. Therefore, always double-check details before beginning your project. Nuvo Iron
TM
, its
advertising agency and delegates shall not be held responsible for injury, damage or any other loss, however caused, resulting from the information contained in these instructions.
3
4
5
7 7
6
7
1
22
22
1
22
22
Cane Bolt
Note - During installation should the
paint get scratched please call Nuvo Iron
TM
for the matching touch up paint.
Post Frame
Post Frame
Mount
Frame Collars 90
0
perpendicular
to gate
Mount
Frame Collars 90
0
perpendicular
to gate
Mount
Frame Collars 90
0
perpendicular
to gate