Installation Guide

3NuvoH2O.com
Package Contents
Materials & Tools Needed
Installation Guide
This package includes:
• System head and mounting bracket
• 1 Cartridge
• 2 Brass hose compression fittings
Because plumbing standards vary, other
bushings and connectors are
not included.
A. Two - braided stainless steel
connectors. If your dishwasher is already
connected you will only need one
additional connector for this installation.
B. PTFE tape.
C. Adjustable wrench.
D. Phillips head screwdriver.
E. Towel.
1. Locate the shutoff valve supplying
water to the dishwasher (this valve is
typically found underneath the kitchen
sink) and turn the water off.
2. Disconnect the Dishwasher System
cartridge from the head by firmly
grasping the cartridge and lift up
on the red cartridge lock mechanism
situated near the “out” port and turn
the cartridge clock-wise a quarter turn
while pulling down.
3. Using a pencil and the mounting
bracket, mark where to mount the
screws. Please ensure the head is as
level as possible and there is enough
room to easily replace the cartridges
after use. We suggest mounting the
head at least 15” above the
cabinet floor.
4. Mount the head of the Dishwasher
System using the screws from the
installation kit.
5. Wrap both ends of the 3/8-inch brass
inserts with PTFE tape (at least three
rotations).
6. Insert one of the 3/8-inch brass inserts
into the “In” port and the second
into the “Out” port of the Dishwasher
System. Tighten gently with the
wrench as needed.
7. Using the adjustable wrench,
disconnect the existing water supply
Dishwasher System