Instructions / Assembly

nuvowater.com
877-688-6426
5
Changing the CitraChargePro Spot-
Free Dishwashing System Cartridge
1 Before replacing your cartridge, we recommend having
a towel underneath your CitraChargePro Dishwasher
System to catch any water that may spill. The Dish
washer System is a quick-connect system but does
not have a built-in by-pass. The system may allow some
of the pressurized water to escape when the cartridge is
removed.
2 Locate and turn-o the valve for the hot water feed line
to the CitraChargePro Dishwasher System.
3 Firmly grasp the cartridge and lift up on the red cartridge
lock mechanism situated near the “out” port and turn the
cartridge clock-wise ¼ turn and pull down to disconnect
and remove the cartridge base from the top hood.
4 Remove and discard the spent cartridge.
5 Line up the replacement cartridge into the housing hood
and with rm, upward pressure twist the new replace
ment cartridge ¼ turn into place.
FIG. 5
3 Adjustable Wrench
4 Drill with a small (1/8”) bit
To create starter holes in your cabinet for the screws that
will hold the CitraChargePro System in place.
5 Phillips head screwdriver
To drive the screws which hold the CitraChargePro
System in place.
STEP 3
Mount the CitraChargePro System
Mount the CitraCharge canister to the side or back wall of
the cabinet beneath the sink and between or adjacent to
the hot water supply line.
Make sure the canister is mounted level and close enough
to connect to the hot water supply line.
Please note the “IN” and “OUT” notations on the System
head. The “IN” side should be closest to your dishwasher
shut-o valve and the “OUT” side closest to the dishwasher.
[While the head can easily be reversed by unscrewing
it from the mounting bracket it is easier to get the head
mounted positioned correctly before you mount the bracket
to the cabinet wall.]
Ensure that the bottom of the System is above the oor of
the cabinet by at least 2” to allow clearance to remove the
canister body when it’s time to change the cartridge.
2
FIG. 1