Instructions / Assembly
nuvowater.com
877-688-6426
3
STEP 4
Disconnect the Water Supply
Shut o the hot-water supply to the dishwasher. Some
homes have a separate shut-o valve just for the dish-
washer line. Some will have a single shut-o valve which
shuts o all the hot water under the sink —to the sink
faucet and the dishwasher. Now use an adjustable wrench
to disconnect the dishwasher hot water supply line that
connects to the faucet supply valve.
STEP 5
Connect the CitraCharge System
Connect the new water supply line to the CitraChargePro
System inlet on one end and to the hot-water supply valve
(where the dishwasher supply line was disconnected) on
the other end. NOTE: The “in” and “out” ports are marked
on the top of the cartridge head.
Now connect the water line from the dishwasher to the
CitraCharge System’s ”out” port.
FIG. 2
FIG. 3
Typical Dishwasher
Water Supply Line
& Shut-o Valve
Water Supply Line to System Inlet
4
Slowly turn on the valve for the hot water feed line to
resume water ow. Check for leaks. If a leak exists, turn
o the water and tighten the water lines. Conrm that the
cartridge is correctly installed. If leak persists, return the
valve to the “O” position and call customer support
(877-688-6426) for additional troubleshooting steps.
FIG. 4
Connected
CitraChargePro
Spot-Free
Dishwashing
System