Quick Start Guide

9
Federal Communication Commission Statement
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Need Help?
Find answers to common questions, how-to guides, and troubleshooting tips at
www.TabloTV.com/support
.
Or, ask other Tablo users on our community forum at
community.TabloTV.com
.
Or, speak directly with our helpful team of support gurus:
support@Tab
loTV.com
1-844-TABLOTV (822-5688)
Twitter.com/Tab
loSupport
Support hours of operation are Monday–Friday, 9:30 a.m. to 5:30 p.m. ET, excluding Canadian holidays. Messages
received outside of those hours will be returned within 1 business day.
Warranties & Returns
We hope you love your Tablo, but if you’re unhappy for any reason we offer a 30-day return policy on new units
purchased through TabloTV.com. For units purchased through retail partners, the retailer’s return policy applies.
All Tablo units include a 100% repair or replacement warranty for 12 months from the original purchase date.
Tablo’s complete warranty and return policy can be found on our website at
www.TabloTV.com/warranty-returns
.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential install
ation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Industry Canada Statement
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to
the following two conditions: (1) This device may not cause interference; and (2) This device
must accept any interference, including interference that may cause undesired operation of
the device.
The distance between user and device should be no less than 20cm.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifi cations not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Déclaration d’Industrie Canada
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre
le fonctionnement.
la distance entre l'utilisation et l'appareil ne doit pas être inférieure à 20 cm.