Full Product Manual

Owner’s Manual
• 13
LED Display
To Start Cooking:
Note: Ensure that your NuWave PIC Double is turned on by
ipping the on/off switch located on the back of the PIC.
Control Panel:
LED Display should read “0” when program is clear or power is on.
There are several ways to begin cooking with your NuWave™ PIC Double:
• Select one of the temperature functions (Low - Max/Sear) then press “Start”.
Default cooking time is 1 hour.
• Press “Cook Temp”, then press “Start”. Default cooking will be 375˚F for 1 hour.
• Press “Cook Temp” then set the cooking temperature using the numeric touchpad
and press “Start”. Default time is 1 hour.
• Press “Cook Time” then set the cooking time using the numeric touchpad and press “Start”.
Default cooking temperature is 375˚F.
• Set the temperature and time using the numeric touchpad, then press “Start”.
The NuWave™ PIC Double will automatically stop cooking once time has expired and a “beep”
sound will alert users. The display will always show the current temperature during the cooking cycle.
To display time lapse, press “Cook Time” while cooking.
NOTE: After 3 seconds, the display will revert to the cooking temperature.
NOTE: Due to ETL regulations regarding touchpad control panels, pressing the “Start” button only
will not begin the cooking process.
Pause/Clear Function:
1. To interrupt cooking time, press the “Pause/Clear” button once.
This will pause the NuWave™ PIC Double at the current stage.
2. The temperature will remain listed in the display panel, but the “F” will be blinking.
3. To resume, press “Start.”
4. To clear the cooking mode or display while the NuWave™ PIC Double is in operation,
press the “Pause/Clear” button twice. The screen will be fully cleared and a “0” or the
current time will appear and the unit will turn off.
Setting Clock And am/pm Button:
1. Press the “Clock” button. CLOCK indicator will ash on LED display
and “00:00” will be displayed.
2. Enter digits to match the current time. For example, 1:25 would be entered by pressing “1,2,5”.
3. Once entered, the time will be set as AM as a default.
4. To change to PM, press the “am/pm” button.
5. Press the “Clock” button again to set.
• “End Time” feature will not work unless the clock is set on each control panel.
• If the NuWave™ PIC Double is cut from a power supply or turned off, the clock must be
reprogrammed on each control panel.
Directions for Each Display Panel
Low
Med
Low
Med High
Cook Temp
Clock
Program
Cook Time
End Time
am/pm
1800W
Stage
1
4
7
2
5
8
0
3
6
9
Start
Med
High
Pause
Clear
Max
Sear
LED
Display
Increase Start
Pause/
Clear
Decrease
Watts
Program
Clock
Cook
Time
Stage
End
Time
Cook
Temperature
Number
AM/PM
Low-Max/Sear