Full Product Manual

Owner’s Manual
• 15
Setting Cooking Time:
1. Press the “Cook Time” button. The “TIME” indicator will ash.
2. Enter the time in hours and minutes using the numeric touchpad.
• For example, 1 hour and 30 minutes
would be entered by pressing “1,3,0”.
The display panel will show 1:30.
• The time can be adjusted in
1 minute increments by pressing
the “-” or “+” arrows.
• To check the time during the cooking process, press the “Cook Time” button,
the PIC will automatically revert to the temperature in 3 seconds.
3. If the required time is in minutes, you only need to enter 1 or 2 numbers.
• For example, for 5 minutes just enter “5”; for 46 minutes, enter “4,6”.
4. If the number needs to be corrected, clear the entry by pressing “0” button
four times.
• The blinking TIME indicates that the time can be adjusted.
The maximum amount of programmable time is 99 hours and 60 minutes.
• The display shows hours and minutes, but not seconds.
Warm Function:
After the initial cooking is complete, the cooktop can be used to keep the
food warm (between 100ºF - 200ºF). The default setting is programmed at 120ºF for 2 hours.
1. Press the “Low” and “Med/Low” buttons simultaneously.
until the display ashes “WARM”.
The “WARM” indicator will blink.
2. 120F will be displayed, then press “Start”.
3. The PIC can be programmed to keep foods
warm for up to 100 hours.
4. Once the initial cooking cycle is nished, the PIC will “beep” twice before switching
to the WARM function. Warm will always be the last stage in the program.
• The temperature of the WARM function can be increased or decreased by pressing
“+” or “-” buttons or using the numeric touchpad.
• To change the warm time press “Cook Time” button. You can increase/decrease the
cooking time by pressing the “+” or “-” buttons or using the numeric touchpad.
Stage Cook Function:
This function is used when programming or cooking for more
than one time and temperature setting.
1. Press the “Stage” button. “STAGE” will
begin ashing on the display. All the stages
have a default temperature of 375ºF.
2. To change the temperature, press the
“Cook Temp” button. “TEMP” will ash on
the display. Enter the desired temperature.
3. Press the “Cook Time” button.
“TIME”will ash on the display.
Enter the desired cooking time.
• You can also start with the “Cook Time”,
followed by the “Cook Temp”.
5. Press the “Stage” button to move onto programming stage “2”.
6. Repeat the process until all desired stages are programmed, then press the “Start” button.
• There is a maximum number of 10 programmable stages.
Stage 10 will be displayed as “0.”
• If would like to edit an already programmed stage at any time, press the “Stage”
button until desired stage is displayed. At that point, you may change the
COOK TEMP, COOK TIME or both.