Full Product Manual

ManualsBrandsNuWave ManualsAppliancesPIC Double Induction Cooktop

18 • NuWave

™

PIC

Double Complete Cookbook

Troubleshooting

Solution

Error

Message

FULL

The unit is malfunctioning. Contact customer service.

An E1 reading typically means that your NuWave™ PIC Double

does not detect cookware on its surface. This can occur for one of

two reasons.

1. The induction coils contained within the NuWave™ PIC Double

will only work when they are in direct contact with a piece of

cookware. To maintain your appliance’s effectiveness, always

ensure that it rests on a at surface and that contact is consistent

with your cookware.

2. An E1 message may also occur if your chosen cookware is

not induction-ready.

The unit’s voltage is too low. Minimum = 85 volts

The unit’s voltage is too high. Maximum = 144 volts

Overheating, or air ventilation is obstructed. If internal temperature

exceeds 230ºF, operation will cease and a “beep” noise will be

produced. Press “Pause/Clear” twice. Wait for the unit to cool.

In programming mode, when the total entered time reaches the

appliance’s limit of 99:60, no additional stages can be inputted.

Overheating, if unit exceeds a temperature 20ºF higher than sear,

the appliance will turn off. Contact customer service.

The unit is malfunctioning. Contact customer service.

• When any of the above error messages display on the LED, the unit will “beep” at

least once.

• The fan will run up to a maximum of 60 seconds after pressing the “Pause/Clear

button once. Continue cooking by pressing the “Start” button within 45 minutes.

• The unit will turn off after 45 minutes if no buttons (such as “Start”) are pressed.

When the unit shuts off, it will clear all previous cooking history.

• After pressing the “Pause/Clear” button twice or cooking has stopped, the fan will run

up to a maximum of 60 seconds until the unit cools. At that point the NuWave™ PIC

Double will turn off.

Beep sound Display Reference

Initial

< 10 seconds

11- 70 seconds

After 70 seconds

Single beep

None

Yes

None

“F” or “C” or

“Sear” Flashing

“F” or “C” or “Sear”

or “:” Flashing

After returning the pot,

NuWave™ PIC Double

will automatically resume

cooking.

Resume cooking by

pressing “Start” button.

Cooking stops.

After removing

cookware