Use and Care Manual

12 • NuWave
™
PIC
®
Double Complete Cookbook
General Operating Instructions:
General Cleaning Instructions:
• Clean after each use.
• Make sure unit has cooled completely prior to cleaning.
• The outer surface may be cleaned by wiping carefully with a damp dishcloth or sponge.
• Remove the power plug prior to cleaning the NuWave™ PIC Double. Do not use caustic
cleaning agents and water should not penetrate the interior of the induction cooktop.
• Never immerse the NuWave™ PIC Double, its cables or plug in water or other liquids.
• Wipe the glass surface with a damp cloth or use a mild, non-abrasive soap
solution. Make sure the unit has cooled completely before cleaning.
• Wipe casing and operating panel with a soft cloth dampened with water or a
mild detergent.
• Do not use oil-based cleansing products as their use may damage plastic parts
or the casing/operating panel.
• Do not use ammable, acidic or alkaline materials or substances near the
NuWave™ PIC Double, as this may reduce the service life of the induction
cooktop or pose a re risk when the induction cooktop is in use.
• In order to keep your NuWave™ PIC Double looking like new, take measures
to ensure that the bottom of cookware does not scrape the unit’s glass surface,
although a scratched surface will not impair the use of the induction cooktop.
• Make sure to properly clean the unit before storing it in a cool, dry place.
• Place the cooktop on a stable, level, non-metallic surface.
• Never use the cooktop on a ammable surface (e.g. table cloth, carpet, etc.).
• Do not block the ventilation slots of the induction cooktop. This may cause
the unit to overheat. Maintain a minimum distance of 3-5 inches from walls
and other objects, appliances, etc.
• Do not place devices or objects that are sensitive to magnetic elds on
top of or next to the NuWave™ PIC Double.
(e.g. credit cards, cell phones, radios, TVs, video recorders, etc.).
• Do not use the induction cooktop in the proximity of open res,
heaters or other heat sources.
• Do not place on stove top.
• Ensure that the power cable is not damaged or compressed
beneath the induction cooktop.
• The power cable must not come into contact with sharp edges and/or hot surfaces.
• Prior to connecting the NuWave™ PIC Double, conrm that the voltage
needs indicated in this manual correspond to the voltage supply in your home.
A wrong connection may lead to the unit’s damage and possible injury to persons.
• The cooktop’s surface is designed from temperature-resistant glass. In the event
that damage to the unit is observed, even a small crack on the glass surface,
immediately disconnect the NuWave™ PIC Double from the power supply.
IMPORTANT TIPS:
1. Check power outlets to ensure proper operation. Do not use in an outlet where other
major appliances are engaged. Check settings if the unit is cooking too slowly.
2. The electrical plug must be properly plugged into the outlet.
3. Always turn off and unplug the unit before wiping.