Use and Care Manual

Operating Instructions

Silicone Gasket Installation

OPERATING INSTRUCTIONS

Open lid: Hold the lid handle. Turn the lid counter clockwise to open position

then raise it. Make sure to install the Water Collector Box.(See below)

Place ingredients and water in the inner pot. Ingredients and water

should not exceed 4/5 height of the inner pot. If the ingredients expand

easily in water, then the total amount should not exceed 3/5 height

of the inner pot. The minimum amount of ingredients and water is

normally 1/5 height of the inner pot. (See below).

Place the inner pot in the Housing. Clean the bottom of inner pot and

surface of heating plate before inserting the inner pot. (See below).

Close lid:

• Check that the Silicone Gasket is secured in the lid before closing.

• Hold the lid handle. Lower the lid, then turn the lid clockwise to close.

A sound will conrm that the lid has been closed properly. (See below).

The push rod on the side

of the lid needs to align

properly to the base in order

for the lid to lock into place.

Right side

Note: Install the

Water Collector

Box on the right

side just below

the handle.

At a 45˚ angle

press in.