FCC WARNING This device complies with part 15 of the FCC Rules. Operation Is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Control Panels Control Panels CHANNEL 1 INPUT Jack CHANNEL @ @ COMBO Jack CHANNEL 2 0 VOLUME Knob BASS Knob MIDDLE Knob TREBLE Knob TUNER Button Display VOLUME Knob SEND Knob REVERB Knob MASTER Knob BLUETOOTH OFFEND Switch Button Channel 1 INPUT Jack INPUT Jack, accept both passive and active acoustic pickups. VOLUME Knob Controls the input signal level for the Channel 1 input. BASS Knob Bass frequency level control. MIDDLE Knob Middle frequency level control. TREBLE Knob Treble frequency level control.
Control Panels Rear Panel BLUETOOTH Button Press this button to engage/disengage the built-in Bluetooth function. For further information please refer to the Bluetooth description. POWER Indicator Lights on steady when the amplifier is on. OFFEND Switch Tum ON/OFF the amplifier. * Please tum down the mater volume before you tum on the amp. 0 DC-IN Jack ed] nL Auxin Monmouth Charge Indicator Low Bart.
Rear Panel DC-IN Jack Plug in the included power supply here to power/charge this amplifier. Use specified power supply only(DC Polarity: Negative tip). Charge Indicator Lights on steady during the charging process. Lights off automatically when the battery is fully charged. Low Bart. Indicator The LED indicator will light on when the battery level is low. For further information, please refer to the BATTERY description. PHONES Jack ¥ Composite audio signal output jack.
Operation Guide TUNING MODE FLAT SHARP INTONE 1.Press the TUNER bunion to active the built-in tuner. 2.Adjust tuning peg of each string according to the tuning visuals on the DISPLAY: 3.When finishing up, press the TUNER button again to quite the tuner mode. *The amplifier will be muted when TUNER is engaged. *Tuner ONLY works with CHANNEL 1. 1.When you power on the amplifier the Bluetooth function will also be tuned on automatically by default.
Technical Specifications ® Speaker: 6.5" , ohm , 50W , 63Hz ~ kHz # Sampling Rate: 44.1kHz Convert: bit «Signal Processing: bit ® Rated Power: 25W «Input Level& Impedance: Channel 1 -bedbug /1M Ohms Channel 2 -bedbug /2K Ohms AUX-IN bedbug / 21k Ohms # Phones Output : 250mW + 250mW #Tuning Range: A0~C8 Ad = 440Hz © DC Power Supply: Negative Tip # Battery Pack Capacity: = Dimensions: 280{L) x 218(D) x ® Weight: 5Kg Supplied Accessories: User Manual, Power Supply “Specification may change without noticed.
