Cut Sheet

CADWELD WELDING MATERIAL, F20, 45

CATALOG NUMBER

CERTIFICATIONS

FEATURES

Mixture consists mainly of copper oxide and aluminum

Primarily used in grounding and bonding applications

Welding material is in the top of the tube and starting material is in the bottom of the tube

Packaged by size in plastic tubes with clear caps

Tubes packaged in plastic boxes along with metal disks

Each welded connection uses a single disk

Non-explosive

Not subject to spontaneous ignition

See specific nVent ERICO Cadweld connection details to determine welding material requirements

WARNING

nVent products shall be installed and used only as indicated in nVent's product instruction sheets and training materials.

Instruction sheets are available at www.nvent.com and from your nVent customer service representative. Improper

installation, misuse, misapplication or other failure to completely follow nVent's instructions and warnings may cause

PAGE 1
CADWELD WELDING MATERIAL, F20, 45 CATALOG NUMBER 45 CERTIFICATIONS FEATURES Mixture consists mainly of copper oxide and aluminum Primarily used in grounding and bonding applications Welding material is in the top of the tube and starting material is in the bottom of the tube Packaged by size in plastic tubes with clear caps Tubes packaged in plastic boxes along with metal disks Each welded connection uses a single disk Non-explosive Not subject to spontaneous ignition See specific nVent ERICO Cadweld co
PAGE 2
product malfunction, property damage, serious bodily injury and death and/or void your warranty. WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov. North America Europe Europe APAC +1.800.753.