User's Manual

January 2010 - 15 -
6) After a further 1-2 seconds, release the recovery button
7) Connect a mini-USB to USB-A cable between the host PC and the mini-USB jack on the
rear-left corner of the devkit main board.
8) If this is the first time that the host PC has been used to flash a devkit device, then you
may be prompted to install the USB driver for the newly-found device. This driver
should have been supplied with the operating system image, as it is dependent upon the
host PC OS used to flash the device. See the following section for a discussion of this
process on Windows XP.
9) Once the driver is confirmed to be running, the device is in recovery mode. Continue
following the platform pack’s OS install instructions to complete the OS installation.
Release