User's Guide

13
community.
To reduce the risk of electric shock, personal injury, or damage to the equipment, observe
the following precautions:
> Follow all cautions and instructions marked on the equipment.
> Do not bend, drop, crush, puncture, incinerate, or push objects into openings of
SHIELD™.
> Do not connect or disconnect any cables or perform maintenance or reconfiguration of
this product during an electrical storm.
> Do not use SHIELD™ in rain or near sink, or other wet locations. Take care not to spill
any food or liquid into the device. In case SHIELD™ gets wet, unplug all cables and turn
off before cleaning, and allow it to dry thoroughly before turning it on again.
> Do not expose SHIELD™ to any gas which is not normally contained in the atmosphere,
it may cause defects.
> Never turn on any equipment when there is evidence of fire, water, or structural damage.
> Place the product away from radiators, heat registers, stoves, amplifiers, or other
appliances that produce heat.
> Never force a connector into a port. Check for obstructions on the port. If the connector
and port don’t join with reasonable ease, they probably don’t match. Make sure that the
connector matches the port and that you have positioned the connector correctly in relation
to the port.
> Always use an NVIDIA approved power adapter and refer to the manufacturer’s
instructions or equipment manual for proper instructions. Do not connect or disconnect the
AC Power Adapter with wet hands. The power adapter is intended for indoor use only.
> Operate the AC adapter in a ventilated area.
> When you are using SHIELD™ or charging the battery, it is normal for the system and/or
AC power adapter to get warm. Always unplug SHIELD Portable when fully charged to
save unnecessary power consumption.
> Do not use conductive tools that could bridge live parts.
> Do not make mechanical or electrical modifications to the equipment.
> Never attempt to repair SHIELD™ yourself. This device does not contain any user-
serviceable parts. Do not attempt to open, disassemble, or remove the battery. You run the
risk of electric shock.
> SHIELD portable: To clean the display, use a soft, lint-free cloth. If necessary, breathe
upon the display surface and wipe off immediately and softly. Avoid getting moisture in
openings. Don’t use window cleaners, household cleaners, aerosol sprays, solvents,
alcohol, ammonia, or abrasives to clean the display.
> Operate SHIELD™ in a place where the temperature is always between 5 and 30°C (41 to
86°F).
> Store SHIELD™ in a place where the temperature is always between 0 and 35°C (32 to
95°F) with a relative humidity of 70% or lower. When taking the device from a low
temperature condition, allow the device to reach room temperature before turning the
power on.
> Use this product only with approved equipment and/or accessories