Spec Sheet

Network Video Technologies
4005 Bohannon Drive • Menlo Park, CA 94025 • USA
(+1) 650.462.8100 • 800.959.9870 • FAX [phone]
nvt.com • [e-mail]
Model NV-16PS10-PVD
Power Supply Cable Integrator Hub
Features:
• Provides Class 2 SELV camera power and pass-through video and telemetry data
connectivity for up to 16 cameras, each via a single RJ45 4-pair UTP cable
• Standard telecom/datacom structured cabling pinouts per EIA/TIA 568B
• Independently selectable 24 or 28VAC with 1 Amp max per channel*
• Automatic-reset fault protection; transient protection
• Individually floating outputs ensure total ground-loop immunity
• Diagnostic LEDs show load/no load, miswires, and overload conditions
• Use with the NV-216A-PV or NV-218A-PVD transceivers or the NV-226J-PV transmitter at the camera
• Power cameras via UTP over significant distances (see Power Distance Chart)
• 1 U high; 12” deep; wall, desk, or rack-mountable
• Limited lifetime warranty
The NVT model NV-16PS10-PVD combines a 1 Amp/channel*† power supply with pass through video
and telemetry data, for up to 16 cameras, all over UTP wire. Designed for installation in the wiring/IDF
telecom closet, or at the Control/MDF room, the NV-16PS10-PVD consolidates connectivity via stan-
dard 4-pair RJ45 EIA/TIA 568B compliant premises wiring and pinouts.
At the camera, Power, Video and Data connections are made using a PVD
TM
transceiver via an RJ45
connector and a single 4-pair cable. Control/MDF room connections are achieved with a single 4-pair
RJ45 cable for each group of four cameras. Consolidated P/T/Z telemetry data, if required, passes through
the NV-16PS10-PVD’s data path, and is connected to the controller via another 4-pair RJ45 cable.
*10 Amps, aggregate to comply with CB / IEC 60065
Rear
Front
-32-