Spec Sheet

Network Video Technologies
4005 Bohannon Drive • Menlo Park, CA 94025 • USA
(+1) 650.462.8100 • 800.959.9870 • FAX [phone]
nvt.com • [e-mail]
-23-
Model NV-704J-PVD
Cable Integrator
Features:
• Connectivity for up to four cameras, each via a single RJ45 4-pair cable
• Use with the NV-216A-PV, NV-218A-PVD, or NV-226J-PV transceiver at the camera
• Uses any third-party power supply to power cameras via UTP over
significant distances (see Power Distance Chart)
• Cable-management solution from the camera to the Wiring Closet and
on to the Control Room
• Wall-mountable; rack-mountable using the NV-RM8/10 panel
• Limited lifetime warranty
Typically installed in the Wiring Closet or IDF room, the NV-704J-PVD is a passive “pass-through” wiring
device that efficiently consolidates camera power, video, and pan/tilt/zoom telemetry data onto a
minimum of 4-pair RJ45 cables.
Power, video and data are converted at the camera using a PVD
TM
transceiver which utilizes a single
4-pair cable with RJ45 connectors to deliver each camera's signals to the NV-704J-PVD. Up to four
cameras are supported. The NV-704J-PVD receives low-voltage camera power from any third-party
Class 2 power supply. Control Room video connections are achieved with a single 4-pair RJ45 cable.
P/T/Z telemetry data, if required, passes through a second 4-pair RJ45 cable and delivers P/T/Z teleme-
try. Control Room connections may be made using any multi-channel NVT receiver or hub. All equip-
ment employs industry-standard EIA/TIA 568B pinouts.