User Manual

Table Of Contents

Jennic

As long as the above condition is met, further transmitter testing will not be required. However,

the OEM integrator is still responsible for testing their end-product for any additional compliance

requirements required with this module installed (for example, digital device emissions, PC

peripheral requirements, etc.).

IMPORTANT NOTE: In the event that these conditions can not be met (for certain

configurations or co-location with another transmitter), then the FCC authorization is no longer

considered valid and the FCC ID can not be used on the final product. In these circumstances,

the OEM integrator will be responsible for re-evaluating the end product (including the

transmitter) and obtaining a separate FCC authorization.

The OEM integrator has to be aware not to provide information to the end user regarding how to

install or remove this RF module in the user manual of the end product.

The user manual for the end product must include the following information in a prominent

location;

“To comply with FCC’s RF radiation exposure requirements, the antenna(s) used for this

transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.”

End Product Labelling

The final ‘end product’ should be labelled in a visible area with the following:

“Contains TX FCC ID: TYOJN5121M0, TYOJN5121M4 or TYOJN5121M6 ” to reflect the

version of the module being used inside the product.

RoHS Compliance

JN5121-xxx-Myy devices meet the requirements of Directive 2002/95/EC of the European Parliament and of the

Council on the Restriction of Hazardous Substance (RoHS).

Status Information

The status of this Data Sheet is Preliminary.

Jennic products progress according to the following format:

Advance

The Data Sheet shows the specification of a product in planning or in development.

The functionality and electrical performance specifications are target values and may be used as a guide to the final

specification.

Jennic reserves the right to make changes to the product specification at anytime without notice.

Preliminary

The Data Sheet shows the specification of a product that is in production, but is not yet fully qualified.