User's Guide

© NXP Laboratories UK 2012 JN-DS-JN5168-001-Myy 1v1 3
1. Introduction
The JN5168-001-Myy module family provides designers with a ready-made component that provides a fully
integrated solution for applications, using the IEEE802.15.4 standard in the 2.4-2.5GHz ISM frequency band [1],
including JenNet-IP and ZigBee Smart Energy, and can be quickly and easily included in product designs. The
modules integrate all of the RF components required, removing the need to perform expensive RF design and test.
Products can be designed by simply connecting sensors and switches to the module IO pins. The modules use
NXP‟s single chip IEEE802.15.4 Wireless Microcontroller, allowing designers to make use of the extensive chip
development support material. Hence, this range of modules allows designers to bring wireless applications to
market in the minimum time with significantly reduced development effort and cost.
Four variants are available: JN5168-001-M00, JN5168-001-M03, JN5168-001-M05 and JN5168-001-M06. All
modules have FCC and Industry Canada modular approvals. All modules other than the JN5168-001-M06 are also
CE compliant and subject to a Notified Body Opinion.
The variants available are described below.
1.1. Variants
1.2. Regulatory Approvals
The JN5168-001-M00, M03 and M05 have been tested against the requirements of the following European
standards.
 Radio EN 300 328 v1.7.1.
 EMC, EN 301 489-17 v2.1.1
 Basic Safety Assessment (BSA) EN 60950-1:2006
A Notified Body statement of opinion for this standard is available on request.
The High Power module with M06 suffix is not approved for use in Europe, instead the JN5168-001-M05 module may
be used with an antenna with up to 2.2dBi; 10mW/MHz power spectral density e.i.r.p is the maximum permitted in
Europe.
Additionally, all module types have received FCC “Modular Approval”, in compliance with CFR 47 FCC part 15
regulations and in accordance to FCC Public notice DA00-1407. Appendix A.8 contains details on the conditions
applying to this modular approval. The modules are approved for use with a range of different antennas; further
details of which can be found in section Appendix A.8.1. The modular approvals notice and test reports are available
on request.
All modules are compliant with Industry Canada RSS210 (Issue 8, Annex 8) and have Industry Canada modular
approval.
The JN5168-001-M06 module is subject to user proximity restrictions under FCC and Industry Canada regulations;
more specific information is available in A.8.2.
Variant
Description
FCCID
Industry Canada ID
JN5168-001-M00
Standard Power, integrated antenna
TYOJN5168M0
7438A-CYO5168M0
JN5168-001-M03
Standard Power, uFL connector
TYOJN5168M3
7438A-CYO5168M3
JN5168-001-M05
Medium Power, uFL connector
TYOJN5168M5
7438A-CYO5168M5
JN5168-001-M06
High Power, uFL connector
TYOJN5168M6
7438A-CYO5168M6