Datasheet

74LVCV2G66 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2013. All rights reserved.
Product data sheet Rev. 5 — 29 March 2013 4 of 23
NXP Semiconductors
74LVCV2G66
Overvoltage tolerant bilateral switch
8. Limiting values
[1] The input and output voltage ratings may be exceeded if the input and output current ratings are observed.
[2] For TSSOP8 package: above 55 C the value of P
tot
derates linearly with 2.5 mW/K.
For VSSOP8 package: above 110 C the value of P
tot
derates linearly with 8 mW/K.
For XSON8 package: above 118 C the value of P
tot
derates linearly with 7.8 mW/K.
9. Recommended operating conditions
[1] To avoid sinking GND current from terminal nZ when switch current flows in terminal nY, the voltage drop across the bidirectional switch
must not exceed 0.4 V. If the switch current flows into terminal nZ, no GND current will flow from terminal nY. In this case, there is no
limit for the voltage drop across the switch.
[2] Applies to control signal levels.
Table 5: Limiting values
In accordance with the Absolute Maximum Rating System (IEC 60134). Voltages are referenced to GND (ground = 0 V).
Symbol Parameter Conditions Min Max Unit
V
CC
supply voltage 0.5 +6.5 V
V
I
input voltage
[1]
0.5 +6.5 V
I
IK
input clamping current V
I
< 0.5 V or V
I
>6.5V 50 - mA
I
SK
switch clamping current V
I
< 0.5 V or V
I
>6.5V - 50 mA
V
SW
switch voltage enable and disable mode 0.5 +6.5 V
I
SW
switch current V
SW
> 0.5 V or V
SW
<6.5V - 50 mA
I
CC
supply current - 100 mA
I
GND
ground current 100 - mA
T
stg
storage temperature 65 +150 C
P
tot
total power dissipation T
amb
= 40 Cto+125C
[2]
- 250 mW
Table 6: Recommended operating conditions
Symbol Parameter Conditions Min Typ Max Unit
V
CC
supply voltage 2.3 - 5.5 V
V
I
input voltage 0 - 5.5 V
V
SW
switch voltage enable and disable mode
[1]
0- 5.5V
T
amb
ambient temperature 40 - +125 C
t/V input transition rise and fall rate V
CC
= 2.3 V to 2.7 V
[2]
--20ns/V
V
CC
= 2.7 V to 5.5 V
[2]
--10ns/V