Datasheet

56F803 Technical Data, Rev. 16
10 Freescale Semiconductor
2.2 Power and Ground Signals
Table 2-2 Power Inputs
No. of Pins Signal Name Signal Description
6 V
DD
Power—These pins provide power to the internal structures of the chip, and should all
be attached to V
DD.
1 V
DDA
Analog Power—This pin is a dedicated power pin for the analog portion of the chip and
should be connected to a low noise 3.3V supply.
Table 2-3 Grounds
No. of Pins Signal Name Signal Description
5 V
SS
GND—These pins provide grounding for the internal structures of the chip, and should all
be attached to V
SS.
1 V
SSA
Analog Ground—This pin supplies an analog ground.
1 TCS TCS—This Schmitt pin is reserved for factory use and must be tied to V
SS
for normal use.
In block diagrams, this pin is considered an additional V
SS.
Table 2-4 Supply Capacitors
No. of
Pins
Signal
Name
Signal
Type
State During
Reset
Signal Description
2 VCAPC Supply Supply VCAPC—Connect each pin to a 2.2 μF or greater bypass capacitor in
order to bypass the core logic voltage regulator (required for proper chip
operation). For more information, please refer to Section 5.2.