User's Manual

UM11016 All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2016. All rights reserved.
User manual Rev. 1.0 — 15 June 2016 13 of 24
NXP Semiconductors
UM11016
ZigBee PRO and IEEE802.15.4 JN5169-001-M0x-2 modules
8.2 Peripherals
The performance of all peripherals is defined in the JN5169 Wireless Microcontroller
Datasheet (see Ref. 2
).
NXP supplies all the development tools and networking stacks needed to enable
end-product development to occur quickly and efficiently. These are all freely available
from the NXP Wireless Connectivity TechZone (see Ref. 3
). A range of
evaluation/developer kits is also available, allowing products to be quickly bread boarded.
Efficient development of software applications is enabled by the provision of a complete,
unlimited, software developer kit. Together with the available libraries for the
IEEE802.15.4 MAC and ZigBee PRO network stacks, this package provides everything
required to develop application code and to trial it with hardware representative of the final
module.
The modules can be user programmed both in development and in production using
software supplied by NXP. Access to the on-chip peripherals, MAC and network stack
software is provided through specific APIs. This information is available on the NXP
support website, together with many example applications, user guides, reference
manuals and application notes.
9. Limiting values
Table 5. Peripherals
Peripherals JN5169-001-M0x-2 Notes
Master SPI-bus port 3 selects 250 kHz - 16 MHz
Slave SPI-bus port 1 250 kHz - 4 MHz
UART 2 16550 compatible
Two-wire serial I/F (compatible with SMbus and I
2
C-bus) 1 Up to 400kHz
PWM 16 MHz clock
timer 4
timer/counter 1
Programmable Sleep Timers 2 32 kHz clock
Digital IO lines (multiplexed with UARTs, timers and SPI-bus
selects)
20 DIO2 and DIO3 are not available
on JN5169-001-M06 modules
Analog-to-Digital converter 4 10-bit, up to 100 ks/s
Programmable analogue comparator 1 ultra low power mode for sleep
Internal temperature sensor 1
Internal battery sensor 1
Table 6. Limiting values
Symbol Parameter Conditions Min Max Unit
V
DD
supply voltage 0.3 +3.6 V
V
VREF/ADC2
voltage on pin VREF/ADC2 0.3 V
DDA
+
0.3V
V
V
ADC1
voltage on pin ADC1 0.3 V
DDA
+
0.3V
V