Datasheet
LPC111X All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2014. All rights reserved.
Product data sheet Rev. 9.2 — 26 March 2014 64 of 127
NXP Semiconductors
LPC1110/11/12/13/14/15
32-bit ARM Cortex-M0 microcontroller
[1] Typical ratings are not guaranteed. The values listed are at room temperature (25 C), nominal supply voltages.
[2] T
amb
=25C.
[3] I
DD
measurements were performed with all pins configured as GPIO outputs driven LOW and pull-up resistors disabled.
[4] IRC enabled; system oscillator disabled; system PLL disabled.
[5] BOD disabled.
[6] All peripherals disabled in the SYSAHBCLKCTRL register. Peripheral clocks to UART and SPI0/1 disabled in system configuration
block.
[7] IRC disabled; system oscillator enabled; system PLL enabled.
[8] All oscillators and analog blocks turned off in the PDSLEEPCFG register; PDSLEEPCFG = 0x0000 18FF.
[9] WAKEUP pin and RESET pin are pulled HIGH externally.
[10] System oscillator enabled; IRC disabled; system PLL disabled.
[11] Low-current mode PWR_LOW_CURRENT selected when running the set_power routine in the power profiles.
[12] Including voltage on outputs in 3-state mode.
[13] V
DD
supply voltage must be present.
[14] 3-state outputs go into 3-state mode in Deep power-down mode.
[15] Allowed as long as the current limit does not exceed the maximum current allowed by the device.
[16] To V
SS
.
I
OL
LOW-level output
current
V
OL
=0.4V; I
2
C-bus pins
configured as Fast-mode
Plus pins
2.5 V V
DD
3.6 V
20--mA
1.8 V V
DD
< 2.5 V 16 - -
I
LI
input leakage current V
I
=V
DD
[16]
-24A
V
I
=5V - 10 22 A
Oscillator pins
V
i(xtal)
crystal input voltage 0.5 1.8 1.95 V
V
o(xtal)
crystal output voltage 0.5 1.8 1.95 V
Pin capacitance
C
io
input/output
capacitance
pins configured for analog
function
--7.1pF
I
2
C-bus pins (PIO0_4 and
PIO0_5)
--2.5 pF
pins configured as GPIO - - 2.8 pF
Table 16. Static characteristics (LPC1100, LPC1100L series) …continued
T
amb
=
40
C to +85
C, unless otherwise specified.
Symbol Parameter Conditions Min Typ
[1]
Max Unit