Datasheet

UM10398 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2014. All rights reserved.
User manual Rev. 12.3 — 10 June 2014 95 of 547
NXP Semiconductors
UM10398
Chapter 7: LPC1100/LPC1100C/LPC1100L series: I/O configuration
7.4.30 IOCON_R_PIO1_1
7.4.31 IOCON_R_PIO1_2
Table 87. IOCON_R_PIO1_1 register (IOCON_R_PIO1_1, address 0x4004 407C) bit
description
Bit Symbol Value Description Reset
value
2:0 FUNC Selects pin function. All other values are reserved. 000
0x0 Selects function R. This function is reserved. Select one of
the alternate functions below.
0x1 Selects function PIO1_1.
0x2 Selects function AD2.
0x3 Selects function CT32B1_MAT0.
4:3 MODE Selects function mode (on-chip pull-up/pull-down resistor
control).
10
0x0 Inactive (no pull-down/pull-up resistor enabled).
0x1 Pull-down resistor enabled.
0x2 Pull-up resistor enabled.
0x3 Repeater mode.
5 HYS Hysteresis. 0
0 Disable.
1 Enable.
6 - - Reserved 1
7 ADMODE Selects Analog/Digital mode 1
0 Analog input mode
1 Digital functional mode
9:8 - - Reserved 00
10 OD Selects pseudo open-drain mode. See Section 7.1
for part
specific details.
0
0 Standard GPIO output
1 Open-drain output
31:11 - - Reserved -
Table 88. IOCON_R_PIO1_2 register (IOCON_R_PIO1_2, address 0x4004 4080) bit
description
Bit Symbol Value Description Reset
value
2:0 FUNC Selects pin function. All other values are reserved. 000
0x0 Selects function R. This function is reserved. Select one of
the alternate functions below.
0x1 Selects function PIO1_2.
0x2 Selects function AD3.
0x3 Selects function CT32B1_MAT1.