Datasheet
LPC2387 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2013. All rights reserved.
Product data sheet Rev. 5.1 — 16 October 2013 5 of 66
NXP Semiconductors
LPC2387
Single-chip 16-bit/32-bit MCU
6. Pinning information
6.1 Pinning
6.2 Pin description
Fig 2. LPC2387 pinning LQFP100 package
LPC2387FBD100
75
26
50
100
76
51
1
25
002aad329
Table 3. Pin description
Symbol Pin Type Description
P0[0] to P0[31] I/O Port 0: Port 0 is a 32-bit I/O port with individual direction controls for each bit.
The operation of port 0 pins depends upon the pin function selected via the pin
connect block. Pins 12, 13, 14, and 31 of this port are not available.
P0[0]/RD1/TXD3/
SDA1
46
[1]
I/O P0[0] — General purpose digital input/output pin.
I RD1 — CAN1 receiver input.
O TXD3 — Transmitter output for UART3.
I/O SDA1 — I
2
C1 data input/output (this is not an open-drain pin).
P0[1]/TD1/RXD3/
SCL1
47
[1]
I/O P0[1] — General purpose digital input/output pin.
O TD1 — CAN1 transmitter output.
I RXD3 — Receiver input for UART3.
I/O SCL1 — I
2
C1 clock input/output (this is not an open-drain pin).
P0[2]/TXD0 98
[1]
I/O P0[2] — General purpose digital input/output pin.
O TXD0 — Transmitter output for UART0.
P0[3]/RXD0 99
[1]
I/O P0[3] — General purpose digital input/output pin.
I RXD0 — Receiver input for UART0.
P0[4]/I2SRX_CLK/
RD2/CAP2[0]
81
[1]
I/O P0[4] — General purpose digital input/output pin.
I/O I2SRX_CLK — Receive Clock. It is driven by the master and received by the
slave. Corresponds to the signal SCK in the I
2
S-bus specification.
I RD2 — CAN2 receiver input.
I CAP2[0] — Capture input for Timer 2, channel 0.