Datasheet

LPC2420_60 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2013. All rights reserved.
Product data sheet Rev. 6.2 — 16 October 2013 74 of 87
NXP Semiconductors
LPC2420/2460
Flashless 16-bit/32-bit microcontroller
In slave mode the input clock signal should be coupled by means of a capacitor of 100 pF
(Figure 29
), with an amplitude between 200 mV (RMS) and 1000 mV (RMS). This
corresponds to a square wave signal with a signal swing of between 280 mV and 1.4 V.
The XTAL2 pin in this configuration can be left unconnected.
External components and models used in oscillation mode are shown in Figure 30
and in
Table 19
and Table 20. Since the feedback resistance is integrated on chip, only a crystal
and the capacitances C
X1
and C
X2
need to be connected externally in case of
fundamental mode oscillation (the fundamental frequency is represented by L, C
L
and
R
S
). Capacitance C
P
in Figure 30 represents the parallel package capacitance and should
not be larger than 7 pF. Parameters F
OSC
, C
L
, R
S
and C
P
are supplied by the crystal
manufacturer.
Fig 30. Oscillator modes and models: oscillation mode of operation and external crystal
model used for C
X1
/C
X2
evaluation
Table 19. Recommended values for C
X1
/C
X2
in oscillation mode (crystal and external
components parameters): low frequency mode
Fundamental oscillation
frequency F
OSC
Crystal load
capacitance C
L
Maximum crystal
series resistance R
S
External load
capacitors C
X1
/C
X2
1 MHz to 5 MHz 10 pF < 300  18 pF, 18 pF
20 pF < 300  39 pF, 39 pF
30 pF < 300  57 pF, 57 pF
5 MHz to 10 MHz 10 pF < 300  18 pF, 18 pF
20 pF < 200  39 pF, 39 pF
30 pF < 100  57 pF, 57 pF
10 MHz to 15 MHz 10 pF < 160  18 pF, 18 pF
20 pF < 60  39 pF, 39 pF
15 MHz to 20 MHz 10 pF < 80  18 pF, 18 pF
002aag469
LPC2xxx
XTAL1 XTAL2
C
X2
C
X1
XTAL
=
C
L
C
P
R
S
L