- NXP ARM Microcontroller Product Data Sheet

DR
AFT
DR
AFT
DRAFT
DR
D
RAFT
DRAFT
DRA
F
T DRAF
D
RAFT DRAFT DRAFT DRAFT DRAFT D
DRAFT
D
RAFT DRA
F
T DRAFT DRAFT DRAFT DRA
LPC2917_19_1 © NXP B.V. 2007. All rights reserved.
Preliminary data sheet Rev. 1.01 — 15 November 2007 43 of 68
NXP Semiconductors
LPC2917/19
ARM9 microcontroller with CAN and LIN
There are two primary clock generators: a low-power ring oscillator (LP_OSC) and a
crystal oscillator. See Figure 12
.
LP_OSC is the source for the BASE_PCR_CLK that clocks the CGU itself and for
BASE_SAFE_CLK that clocks a minimum of other logic in the device (like the watchdog
timer). To prevent the device from losing its clock source LP_OSC cannot be put into
power-down. The crystal oscillator can be used as source for high-frequency clocks or as
an external clock input if a crystal is not connected.
Secondary clock generators are a PLL and seven fractional dividers (FDIV0..6). The PLL
has three clock outputs: normal, 120° phase-shifted and 240° phase-shifted.
Configuration of the CGU: For every output generator - generating the base clocks - a
choice can be made from the primary and secondary clock generators according to
Figure 13
.
Fig 12. Block diagram of the CGU
LP_OSC
Xtal
Oscilator
PLL
Clock Source Bus
Frequency
Monitor
Clock
Detection
DTL MMIO Interface
FDIV0
FDIV1
FDIV6
OUT 0
OUT 1
OUT 9