Datasheet

LPC435X_3X_2X_1X All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2014. All rights reserved.
Product data sheet Rev. 4 — 19 August 2014 40 of 158
NXP Semiconductors
LPC435x/3x/2x/1x
32-bit ARM Cortex-M4/M0 microcontroller
PB_5 A12 - 181 -
[2]
N;
PU
- R — Function reserved.
I/O USB1_ULPI_D4 — ULPI link bidirectional data line 4.
O LCD_VD14 — LCD data.
- R — Function reserved.
I/O GPIO5[25] — General purpose digital input/output pin.
I CTIN_7 — SCT input 7.
O LCD_PWR — LCD panel power enable.
- R — Function reserved.
PB_6 A6 - - -
[5]
N;
PU
- R — Function reserved.
I/O USB1_ULPI_D3 — ULPI link bidirectional data line 3.
O LCD_VD13 — LCD data.
- R — Function reserved.
I/O GPIO5[26] — General purpose digital input/output pin.
I CTIN_6 — SCT input 6. Capture input 1 of timer 3.
O LCD_VD19 — LCD data.
- R — Function reserved.
AI ADC0_6 — ADC0 and ADC1, input channel 6. Configure the
pin as GPIO input and use the ADC function select register in
the SCU to select the ADC.
PC_0 D4 - 7 -
[5]
N;
PU
- R — Function reserved.
I USB1_ULPI_CLK — ULPI link CLK signal. 60 MHz clock
generated by the PHY.
- R — Function reserved.
I/O ENET_RX_CLK — Ethernet Receive Clock (MII interface).
O LCD_DCLK — LCD panel clock.
- R — Function reserved.
- R — Function reserved.
I/O SD_CLK — SD/MMC card clock.
AI ADC1_1 — ADC1 and ADC0, input channel 1. Configure the
pin as input (USB_ULPI_CLK) and use the ADC function
select register in the SCU to select the ADC.
PC_1 E4 - 9 -
[2]
N;
PU
I/O USB1_ULPI_D7 — ULPI link bidirectional data line 7.
- R — Function reserved.
I U1_RI — Ring Indicator input for UART 1.
O ENET_MDC — Ethernet MIIM clock.
I/O GPIO6[0] — General purpose digital input/output pin.
- R — Function reserved.
I T3_CAP0 — Capture input 0 of timer 3.
O SD_VOLT0 — SD/MMC bus voltage select output 0.
Table 3. Pin description
…continued
Pin name
LBGA256 TFBGA100 LQFP208 LQFP144 Reset state [1] Type
Description