Datasheet

LPC4350_30_20_10 All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2014. All rights reserved.
Product data sheet Rev. 4.2 — 18 August 2014 22 of 155
NXP Semiconductors
LPC4350/30/20/10
32-bit ARM Cortex-M4/M0 microcontroller
P3_8 C10 C9 E7 124
[2]
N;
PU
- R — Function reserved.
I SPI_SSEL — Slave Select for SPI. Note that this pin in an
input pin only. The SPI in master mode cannot drive the CS
input on the slave. Any GPIO pin can be used for SPI chip
select in master mode.
I/O SSP0_MOSI — Master Out Slave in for SSP0.
I/O SPIFI_CS — SPIFI serial flash chip select.
I/O GPIO5[11] — General purpose digital input/output pin.
I/O SSP0_SSEL — Slave Select for SSP0.
- R — Function reserved.
- R — Function reserved.
P4_0 D5 D4 - 1
[2]
N;
PU
I/O GPIO2[0] — General purpose digital input/output pin.
O MCOA0 — Motor control PWM channel 0, output A.
I NMI — External interrupt input to NMI.
- R — Function reserved.
- R — Function reserved.
O LCD_VD13 — LCD data.
I/O U3_UCLK — Serial clock input/output for USART3 in
synchronous mode.
- R — Function reserved.
P4_1 A1 D3 - 3
[5]
N;
PU
I/O GPIO2[1] — General purpose digital input/output pin.
O CTOUT_1 — SCTimer/PWM output 1. Match output 3 of timer
3.
O LCD_VD0 — LCD data.
- R — Function reserved.
- R — Function reserved.
O LCD_VD19 — LCD data.
O U3_TXD — Transmitter output for USART3.
I ENET_COL — Ethernet Collision detect (MII interface).
AI ADC0_1 — ADC0 and ADC1, input channel 1. Configure the
pin as GPIO input and use the ADC function select register in
the SCU to select the ADC.
Table 3. Pin description
…continued
LCD, Ethernet, USB0, and USB1 functions are not available on all parts. See Table 2.
Symbol
LBGA256 TFBGA180 TFBGA100 LQFP144 Reset state [1] Type
Description