Datasheet

LPC4350_30_20_10 All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2014. All rights reserved.
Product data sheet Rev. 4.2 — 18 August 2014 35 of 155
NXP Semiconductors
LPC4350/30/20/10
32-bit ARM Cortex-M4/M0 microcontroller
P8_7 K1 J1 - -
[2]
N;
PU
I/O GPIO4[7] — General purpose digital input/output pin.
O USB1_ULPI_STP — ULPI link STP signal. Asserted to end or
interrupt transfers to the PHY.
- R — Function reserved.
O LCD_VD4 — LCD data.
O LCD_PWR — LCD panel power enable.
- R — Function reserved.
- R — Function reserved.
I T0_CAP3 — Capture input 3 of timer 0.
P8_8 L1 K1 - -
[2]
N;
PU
- R — Function reserved.
I USB1_ULPI_CLK — ULPI link CLK signal. 60 MHz clock
generated by the PHY.
- R — Function reserved.
- R — Function reserved.
- R — Function reserved.
- R — Function reserved.
O CGU_OUT0 — CGU spare clock output 0.
O I2S1_TX_MCLK — I2S1 transmit master clock.
P9_0 T1 P1 - -
[2]
N;
PU
I/O GPIO4[12] — General purpose digital input/output pin.
O MCABORT
— Motor control PWM, LOW-active fast abort.
- R — Function reserved.
- R — Function reserved.
- R — Function reserved.
I ENET_CRS — Ethernet Carrier Sense (MII interface).
I/O SGPIO0 — General purpose digital input/output pin.
I/O SSP0_SSEL — Slave Select for SSP0.
P9_1 N6 P4 - -
[2]
N;
PU
I/O GPIO4[13] — General purpose digital input/output pin.
O MCOA2 — Motor control PWM channel 2, output A.
- R — Function reserved.
- R — Function reserved.
I/O I2S0_TX_WS — Transmit Word Select. It is driven by the
master and received by the slave. Corresponds to the signal
WS in the I
2
S-bus specification.
I ENET_RX_ER — Ethernet receive error (MII interface).
I/O SGPIO1 — General purpose digital input/output pin.
I/O SSP0_MISO — Master In Slave Out for SSP0.
Table 3. Pin description
…continued
LCD, Ethernet, USB0, and USB1 functions are not available on all parts. See Table 2.
Symbol
LBGA256 TFBGA180 TFBGA100 LQFP144 Reset state [1] Type
Description