Datasheet

LPC4350_30_20_10 All information provided in this document is subject to legal disclaimers. © NXP Semiconductors N.V. 2014. All rights reserved.
Product data sheet Rev. 4.2 — 18 August 2014 54 of 155
NXP Semiconductors
LPC4350/30/20/10
32-bit ARM Cortex-M4/M0 microcontroller
PF_6 E7 - - -
[5]
N;
PU
- R — Function reserved.
I/O U3_DIR — RS-485/EIA-485 output enable/direction control for
USART3.
I/O SSP1_MISO — Master In Slave Out for SSP1.
O TRACEDATA[1] — Trace data, bit 1.
I/O GPIO7[20] — General purpose digital input/output pin.
- R — Function reserved.
I/O SGPIO5 — General purpose digital input/output pin.
I/O I2S1_TX_SDA — I2S1 transmit data. It is driven by the
transmitter and read by the receiver. Corresponds to the signal
SD in the I
2
S-bus specification.
AI ADC1_3 — ADC1 and ADC0, input channel 3. Configure the
pin as GPIO input and use the ADC function select register in
the SCU to select the ADC.
PF_7 B7 - - -
[5]
N;
PU
- R — Function reserved.
I/O U3_BAUD — Baud pin for USART3.
I/O SSP1_MOSI — Master Out Slave in for SSP1.
O TRACEDATA[2] — Trace data, bit 2.
I/O GPIO7[21] — General purpose digital input/output pin.
- R — Function reserved.
I/O SGPIO6 — General purpose digital input/output pin.
I/O I2S1_TX_WS — Transmit Word Select. It is driven by the
master and received by the slave. Corresponds to the signal
WS in the I
2
S-bus specification.
AI/
O
ADC1_7 — ADC1 and ADC0, input channel 7 or band gap
output. Configure the pin as GPIO input and use the ADC
function select register in the SCU to select the ADC.
PF_8 E6 - - -
[5]
N;
PU
- R — Function reserved.
I/O U0_UCLK — Serial clock input/output for USART0 in
synchronous mode.
I CTIN_2 — SCTimer/PWM input 2. Capture input 2 of timer 0.
O TRACEDATA[3] — Trace data, bit 3.
I/O GPIO7[22] — General purpose digital input/output pin.
- R — Function reserved.
I/O SGPIO7 — General purpose digital input/output pin.
- R — Function reserved.
AI ADC0_2 — ADC0 and ADC1, input channel 2. Configure the
pin as GPIO input and use the ADC function select register in
the SCU to select the ADC.
Table 3. Pin description
…continued
LCD, Ethernet, USB0, and USB1 functions are not available on all parts. See Table 2.
Symbol
LBGA256 TFBGA180 TFBGA100 LQFP144 Reset state [1] Type
Description