Datasheet

LPC4370 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2013. All rights reserved.
Product data sheet Rev. 2 — 21 October 2013 36 of 150
NXP Semiconductors
LPC4370
32-bit ARM Cortex-M4/M0 microcontroller
PB_5 A12 -
[3]
I; PU - R — Function reserved.
I/O USB1_ULPI_D4 — ULPI link bidirectional data line 4.
O LCD_VD14 — LCD data.
- R — Function reserved.
I/O GPIO5[25] — General purpose digital input/output pin.
I CTIN_7 — SCT input 7.
O LCD_PWR — LCD panel power enable.
- R — Function reserved.
PB_6 A6 -
[6]
[13]
I; PU - R — Function reserved.
I/O USB1_ULPI_D3 — ULPI link bidirectional data line 3.
O LCD_VD13 — LCD data.
- R — Function reserved.
I/O GPIO5[26] — General purpose digital input/output pin.
I CTIN_6 — SCT input 6. Capture input 1 of timer 3.
O LCD_VD19 — LCD data.
- R — Function reserved.
AI ADC0_6 — ADC0, input channel 6. Configure the pin as GPIO input and use
the ADC function select register in the SCU to select the ADC.
PC_0 D4 -
[6]
[13]
I; PU - R — Function reserved.
I USB1_ULPI_CLK — ULPI link CLK signal. 60 MHz clock generated by the
PHY.
- R — Function reserved.
I/O ENET_RX_CLK — Ethernet Receive Clock (MII interface).
O LCD_DCLK — LCD panel clock.
- R — Function reserved.
- R — Function reserved.
I/O SD_CLK — SD/MMC card clock.
AI ADC1_1 — ADC1 and ADC0, input channel 1. Configure the pin as input
(USB_ULPI_CLK) and use the ADC function select register in the SCU to
select the ADC.
PC_1 E4 -
[3]
I; PU I/O USB1_ULPI_D7 — ULPI link bidirectional data line 7.
- R — Function reserved.
I U1_RI — Ring Indicator input for UART 1.
O ENET_MDC — Ethernet MIIM clock.
I/O GPIO6[0] — General purpose digital input/output pin.
- R — Function reserved.
I T3_CAP0 — Capture input 0 of timer 3.
O SD_VOLT0 — SD/MMC bus voltage select output 0.
Table 3. Pin description
…continued
LCD, Ethernet, USB0, and USB1 functions are not available on all parts. See Table 2.
Symbol
LBGA256 TFBGA100 Reset state [2] Type
Description