Datasheet

LPC4370 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2013. All rights reserved.
Product data sheet Rev. 2 — 21 October 2013 37 of 150
NXP Semiconductors
LPC4370
32-bit ARM Cortex-M4/M0 microcontroller
PC_2 F6 -
[3]
I; PU I/O USB1_ULPI_D6 — ULPI link bidirectional data line 6.
- R — Function reserved.
I U1_CTS — Clear to Send input for UART 1.
O ENET_TXD2 — Ethernet transmit data 2 (MII interface).
I/O GPIO6[1] — General purpose digital input/output pin.
- R — Function reserved.
- R — Function reserved.
O SD_RST — SD/MMC reset signal for MMC4.4 card.
PC_3 F5 -
[6]
I; PU I/O USB1_ULPI_D5 — ULPI link bidirectional data line 5.
- R — Function reserved.
O U1_RTS — Request to Send output for UART 1. Can also be configured to
be an RS-485/EIA-485 output enable signal for UART 1.
O ENET_TXD3 — Ethernet transmit data 3 (MII interface).
I/O GPIO6[2] — General purpose digital input/output pin.
- R — Function reserved.
- R — Function reserved.
O SD_VOLT1 — SD/MMC bus voltage select output 1.
AI ADC1_0 — ADC1, input channel 0. Configure the pin as GPIO input and use
the ADC function select register in the SCU to select the ADC.
PC_4 F4 -
[3]
I; PU - R — Function reserved.
I/O USB1_ULPI_D4 — ULPI link bidirectional data line 4.
- R — Function reserved.
ENET_TX_EN — Ethernet transmit enable (RMII/MII interface).
I/O GPIO6[3] — General purpose digital input/output pin.
- R — Function reserved.
I T3_CAP1 — Capture input 1 of timer 3.
I/O SD_DAT0 — SD/MMC data bus line 0.
PC_5 G4 -
[3]
I; PU - R — Function reserved.
I/O USB1_ULPI_D3 — ULPI link bidirectional data line 3.
- R — Function reserved.
O ENET_TX_ER — Ethernet Transmit Error (MII interface).
I/O GPIO6[4] — General purpose digital input/output pin.
- R — Function reserved.
I T3_CAP2 — Capture input 2 of timer 3.
I/O SD_DAT1 — SD/MMC data bus line 1.
Table 3. Pin description
…continued
LCD, Ethernet, USB0, and USB1 functions are not available on all parts. See Table 2.
Symbol
LBGA256 TFBGA100 Reset state [2] Type
Description