Datasheet

56F8036 Data Sheet, Rev. 6
90 Freescale Semiconductor
6.3.9.14 PWM Clock Enable (PWM)—Bit 0
• 0 = The clock is not provided to the PWM module (the PWM module is disabled)
• 1 = The clock is enabled to the PWM module
6.3.10 Peripheral Clock Enable Register 1 (SIM_PCE1)
See Section 6.3.9 for general information about Peripheral Clock Enable registers.
Figure 6-11 Peripheral Clock Enable Register 1 (SIM_PCE1)
6.3.10.1 Reserved—Bit 15
This bit field is reserved. It must be set to 0.
6.3.10.2 Programmable Interval Timer 2 Clock Enable (PIT2)—Bit 14
• 0 = The clock is not provided to the PIT2 module (the PIT2 module is disabled)
• 1 = The clock is enabled to the PIT2 module
6.3.10.3 Programmable Interval Timer 1 Clock Enable (PIT1)—Bit 13
• 0 = The clock is not provided to the PIT1 module (the PIT1 module is disabled)
• 1 = The clock is enabled to the PIT1 module
6.3.10.4 Programmable Interval Timer 0 Clock Enable (PIT0)—Bit 12
• 0 = The clock is not provided to the PIT0 module (the PIT0 module is disabled)
• 1 = The clock is enabled to the PIT0 module
6.3.10.5 Reserved—Bits 11–4
This bit field is reserved. Each bit must be set to 0.
6.3.10.6 Quad Timer A, Channel 3 Clock Enable (TA3)—Bit 3
• 0 = The clock is not provided to the Timer A3 module (the Timer A3 module is disabled)
• 1 = The clock is enabled to the Timer A3 module
6.3.10.7 Quad Timer A, Channel 2 Clock Enable (TA2)—Bit 2
• 0 = The clock is not provided to the Timer A2 module (the Timer A2 module is disabled)
• 1 = The clock is enabled to the Timer A2 module
6.3.10.8 Quad Timer A, Channel 1 Clock Enable (TA1)—Bit 1
• 0 = The clock is not provided to the Timer A1 module (the Timer A1 module is disabled)
• 1 = The clock is enabled to the Timer A1 module
Base + $D 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Read
0
PIT2 PIT1 PIT0
0 0 0 0 0 0 0 0
TA3 TA2 TA1 TA0
Write
RESET
0000000 000000 00 0