Datasheet

56F8345 Technical Data, Rev. 17
32 Freescale Semiconductor
Preliminary
FAULTA0 67 Schmitt
Input
Input,
pull-up
enabled
FAULTA0 - 2 — These three fault input pins are used for
disabling selected PWMA outputs in cases where fault
conditions originate off-chip.
To deactivate the internal pull-up resistor, set the PWMA0 bit in
the SIM_PUDR register. See Part 6.5.6 for details.
FAULTA1 68
FAULTA2 69
FAULTA3 70 Schmitt
Input
Input,
pull-up
enabled
FAULTA3 — This fault input pin is used for disabling selected
PWMA outputs in cases where fault conditions originate off-chip.
To deactivate the internal pull-up resistor, set the PWMA1 bit in
the SIM_PUDR register. See Part 6.5.6 for details.
PWMB0 32 Output In reset,
output is
disabled,
pull-up is
enabled
PWMB0 - 5 — Six PWMB output pins.
PWMB1 33
PWMB2 34
PWMB3 37
PWMB4 38
PWMB5 39
ISB0
(GPIOD10)
48 Schmitt
Input
Schmitt
Input/
Output
Input,
pull-up
enabled
ISB0 - 2 — These three input current status pins are used for
top/bottom pulse width correction in complementary channel
operation for PWMB.
Port D GPIO — These GPIO pins can be individually
programmed as input or output pins.
At reset, these pins default to ISB functionality.
To deactivate the internal pull-up resistor, clear the appropriate
bit of the GPIOD_PUR register. See Part 6.5.6 for details.
ISB1
(GPIOD11)
50
ISB2
(GPIOD12)
51
FAULTB0 54 Schmitt
Input
Input,
pull-up
enabled
FAULTB0 - 3 — These four fault input pins are used for
disabling selected PWMB outputs in cases where fault
conditions originate off-chip.
To deactivate the internal pull-up resistor, set the PWMB bit in
the SIM_PUDR register. See Part 6.5.6 for details.
FAULTB1 55
FAULTB2 56
FAULTB3
57
ANA0 80 Input Analog
Input
ANA0 - 3 — Analog inputs to ADC A, channel 0
ANA1 81
ANA2 82
ANA3 83
Table 2-2 Signal and Package Information for the 128-Pin LQFP
Signal
Name
Pin No. Type
State
During
Reset
Signal Description