Datasheet

56F8346 Technical Data, Rev. 15
2 Freescale Semiconductor
Preliminary
Document Revision History
Version History Description of Change
Rev 1.0 Pre-Release version, Alpha customers only
Rev 2.0 Initial Public Release
Rev 3.0 Corrected typo in Table 10-4, Flash Endurance is 10,000 cycles. Addressed additional
grammar issues.
Rev 4.0 Added “Typical Min” values to Table 10-16. Edited grammar, spelling, consistency of
language throughout family. Updated values in Current Consumption per Power Supply Pin,
Table 10-7, Regulator Parameters, Table 10-9, External Clock Operation Timing
Requirements Table 10-13, SPI Timing, Table 10-18, ADC Parameters, Table 10-24, and IO
Loading Coefficients at 10MHz, Table 10-25.
Rev 5.0 Added Part 4.8. Added the word “access” to FM Error Interrupt in Table 4-5. Removed min
and max numbers. Clarified CSBAR 0 and CSBAR 1 reset values in Table 4-10. Removed
min and max numbers, only documenting Typ. numbers for LVI in Table 10-6.
Rev 6.0 Updated numbers in Table 10-7 and Table 10-8 with more recent data. Corrected typo in
Table 10-3 in Pd characteristics.
Rev 7.0 Replaced any reference to Flash Interface Unit with Flash Memory Module. Added note to
V
CAP
pin in Table 2-2. Removed unneccessary notes in Table 10-12. Corrected temperature
range in Table 10-14. Added ADC calibration information to Table 10-24 and new graphs in
Figure 10-21.
Rev 8.0 Clarified Table 10-22. Corrected Digital Input Current Low (pull-up enabled) numbers in
Table 10-5. Removed text and Table 10-2. Replaced with note to Table 10-1.
Rev 9.0
Added 56F8146 information; edited to indicate differences in 56F8346 and 56F8146. Refor-
matted for Freescale look and feel. Updated Temperature Sensor and ADC tables, then
updated balance of electrical tables for consistency throughout family. Clarified I/O power
description in Table 2-2, added note to Table 10-7 and clarified Section 12.3.
Rev 10.0
Added output voltage maximum value and note to clarify in Table 10-1; also removed overall
life expectancy note, since life expectancy is dependent on customer usage and must be
determined by reliability engineering. Clarified value and unit measure for Maximum allowed
P
D
in Table 10-3. Corrected note about average value for Flash Data Retention in
Table 10-4. Added new RoHS-compliant orderable part numbers in Table 13-1.
Rev 11.0 Updated Table 10-24 to reflect new value for maximum Uncalibrated Gain Error
Rev 12.0 Deleted RSTO from Pin Group 2 (listed after Table 10-1). Deleted formula for Max Ambient
Operating Temperature (Automotive) and Max Ambient Operating Temperature (Industrial) in
Table 10-4. Added RoHS-compliance and “pb-free” language to back cover.
Rev 13.0 Updated JTAG ID in Section 6.5.4. Added information/corrected state during reset in
Table 2-2. Clarified external reference crystal frequency for PLL in Table 10-14 by increasing
maximum value to 8.4MHz.