Datasheet

56F8357 Technical Data, Rev. 15
2 Freescale Semiconductor
Preliminary
Document Revision History
Version History Description of Change
Rev 1.0 Initial Public Release
Rev 2.0
Added Package Pins to GPIO Table in Part 8 General Purpose Input/Output (GPIO). Added
“Typical Min” values to Table 10-17. Editing grammar, spelling, consistency of language throughout
family. Updated values in Regulator Parameters Table 10-9; External Clock Operation Timing
Requirements Table 10-13; SPI Timing Table 10-18; ADC Parameters Table 10-24; and IO Loading
Coefficients at 10MHz Table 10-25.
Rev 3.0
Corrected Table 4-6 Data Memory Map - changed address X:$FF0000 to X:$FFFF00
Rev 4.0
Added Part 4.8, added the word “access” to FM Error Interrupt in Table 4-5, documenting only Typ.
numbers for LVI in Table 10-6, updated EMI numbers and write-up in Part 10.8.
Rev 5.0
Updated numbers in Table 10-7 and Table 10-8 with more recent data. Corrected typo in Table 10-3
in Pd characteristics.
Rev 6.0
Replace any reference to Flash Interface Unit with Flash Module; removed references to JTAG pin
DE; corrected pin number for D14 in Table 2-2; added note to V
CAP
pin in Table 2-2; corrected
thermal numbers for 160 LQFP in Table 10-3; removed unneccessary notes in Table 10-12; corrected
temperature range in Table 10-14; added ADC calibration information to Table 10-24 and new graphs
in Figure 10-22.
Rev 7.0
Adding/clarifing notes to Table 4-4 to help clarify independent program flash blocks and other
Program Flash modes, clarification in Table 10-23, corrected Digital Input Current Low (pull-up
enabled) numbers in
Table 10-5. Removed text and Table 10-2; replaced with note to Table 10-1.
Rev 8.0 Added 56F8157 information; edited to indicate differences in 56F8357 and 56F8157. Reformatted for
Freescale look and feel. Updated Temperature Sensor and ADC tables, then updated balance of elec-
trical tables for consistency throughout the family. Clarified I/O power description in Table 2-2, added
note to Table 10-7 and clarified Section 12.3.
Rev 9.0 Added output voltage maximum value and note to clarify in Table 10-1; also removed overall life
expectancy note, since life expectancy is dependent on customer usage and must be determined by
reliability engineering. Clarified value and unit measure for Maximum allowed P
D
in Table 10-3. Cor-
rected note about average value for Flash Data Retention in Table 10-4. Added new RoHS-compliant
orderable part numbers in Table 13-1.
Rev 10.0
Added 160MAPBGA information,TA equation updated in Table 10-4 and additional minor edits
throughout data sheet
Rev 11.0
Updated Table 10-24 to reflect new value for maximum Uncalibrated Gain Error
Rev. 12.0
Deleted formula for Max Ambient Operating Temperature (Automotive) and Max Ambient Operating
Temperature (Industrial) in Table 10-4. Added RoHS-compliance and “pb-free” language to back
cover.
Rev. 13.0
Corrected Section 6.4 title (from Operation Mode Register to Operating Mode Register). Added
information/corrected state during reset in Table 2-2. Clarified external reference crystal frequency for
PLL in Table 10-14 by increasing maximum value to 8.4MHz.
Rev. 14.0
Replaced “Tri-stated” with an explanation in State During Reset column in Table 2-2.