Datasheet
56F8365 Technical Data, Rev. 9
114 Freescale Semiconductor
• 1 = OnCE clock to 56800E core is always enabled
6.5.1.3 Software Reset (SW RST)—Bit 4
This bit is always read as 0. Writing a 1 to this bit will cause the part to reset.
6.5.1.4 Stop Disable (STOP_DISABLE)—Bits 3–2
• 00 = Stop mode will be entered when the 56800E core executes a STOP instruction
• 01 = The 56800E STOP instruction will not cause entry into Stop mode; STOP_DISABLE can be
reprogrammed in the future
• 10 = The 56800E STOP instruction will not cause entry into Stop mode; STOP_DISABLE can then only be
changed by resetting the device
• 11 = Same operation as 10
6.5.1.5 Wait Disable (WAIT_DISABLE)—Bits 1–0
• 00 = Wait mode will be entered when the 56800E core executes a WAIT instruction
• 01 = The 56800E WAIT instruction will not cause entry into Wait mode; WAIT_DISABLE can be
reprogrammed in the future
• 10 = The 56800E WAIT instruction will not cause entry into Wait mode; WAIT_DISABLE can then only
be changed by resetting the device
• 11 = Same operation as 10
6.5.2 SIM Reset Status Register (SIM_RSTSTS)
Bits in this register are set upon any system reset and are initialized only by a Power-On Reset (POR). A
reset (other than POR) will only set bits in the register; bits are not cleared. Only software should clear this
register.
Figure 6-4 SIM Reset Status Register (SIM_RSTSTS)
6.5.2.1 Reserved—Bits 15–6
This bit field is reserved or not implemented. It is read as 0 and cannot be modified by writing.
6.5.2.2 Software Reset (SWR)—Bit 5
When 1, this bit indicates that the previous reset occurred as a result of a software reset (write to SW RST
bit in the SIM_CONTROL register). This bit will be cleared by any hardware reset or by software. Writing
a 0 to this bit position will set the bit, while writing a 1 to the bit will clear it.
6.5.2.3 COP Reset (COPR)—Bit 4
When 1, the COPR bit indicates the Computer Operating Properly (COP) timer-generated reset has
Base + $1
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Read
0 0 O 0 0 0 0 0 0 0
SWR COPR EXTR POR
0 0
Write
RESET
0000000000 00