Datasheet

Signal Pins
56F8365 Technical Data, Rev. 9
Freescale Semiconductor 31
PWMA0 58 Output In reset,
output is
disabled
PWMA0 - 5 — These are six PWMA output pins.
PWMA1 60
PWMA2 61
PWMA3 63
PWMA4 64
PWMA5 66
ISA0
(GPIOC8)
104 Schmitt
Input
Schmitt
Input/
Output
Input,
pull-up
enabled
ISA0 - 2 — These three input current status pins are used for
top/bottom pulse width correction in complementary channel
operation for PWMA.
Port C GPIO — These GPIO pins can be individually
programmed as input or output pins.
In the 56F8365, these pins default to ISA functionality.
In the 56F8165, the default state is not one of the functions
offered and must be reconfigured.
To deactivate the internal pull-up resistor, clear the appropriate bit
of the GPIOC_PUR register. See Part 6.5.6 for details.
ISA1
(GPIOC9)
105
ISA2
(GPIOC10)
106
FAULTA0 67 Schmitt
Input
Input,
pull-up
enabled
FAULTA0 - 2 — These three fault input pins are used for
disabling selected PWMA outputs in cases where fault conditions
originate off-chip.
To deactivate the internal pull-up resistor, set the PWMA0 bit in
the SIM_PUDR register. See Part 6.5.6 for details.
FAULTA1 68
FAULTA2 69
FAULTA3 70 Schmitt
Input
Input,
pull-up
enabled
FAULTA3 — This fault input pin is used for disabling selected
PWMA outputs in cases where fault conditions originate off-chip.
To deactivate the internal pull-up resistor, set the PWMA1 bit in
the SIM_PUDR register. See Part 6.5.6 for details.
Table 2-2 Signal and Package Information for the 128-Pin LQFP (Continued)
Signal
Name
Pin No. Type
State
During
Reset
Signal Description