Datasheet

EEPROM-1 Register Descriptions
MC68HC908AZ60A • MC68HC908AS60A • MC68HC908AS60E Data Sheet, Rev. 6
Freescale Semiconductor 81
6.5.3 EEPROM-1 Nonvolatile Register
The contents of this register is loaded into the EEPROM-1 array configuration register (EE1ACR) after a
reset.
This register is erased and programmed in the same way as an EEPROM byte. (See 6.5.1 EEPROM-1
Control Register for individual bit descriptions).
NOTE
The EE1NVR will leave the factory programmed with $F0 such that the full
array is available and unprotected.
6.5.4 EEPROM-1 Timebase Divider Register
The 16-bit EEPROM-1 timebase divider register consists of two 8-bit registers: EE1DIVH and EE1DIVL.
The 11-bit value in this register is used to configure the timebase divider circuit to obtain the 35 μs
timebase for EEPROM-1 control.
These two read/write registers are respectively loaded with the contents of the EEPROM-1 timebase
divider nonvolatile registers (EE1DIVHNVR and EE1DIVLNVR) after a reset.
Address: $FE1C
Bit 7 6 5 4 3 2 1 Bit 0
Read:
UNUSED UNUSED UNUSED EEPRTCT EEBP3 EEBP2 EEBP1 EEBP0
Write:
Reset: PV
PV = Programmed value or 1 in the erased state.
Figure 6-4. EEPROM-1 Nonvolatile Register (EE1NVR)
Address: $FE1A
Bit 7 6 5 4 3 2 1 Bit 0
Read:
EEDIVS-
ECD
0000
EEDIV10 EEDIV9 EEDIV8
Write:
Reset: Contents of EE1DIVHNVR ($FE10), Bits [6:3] = 0
= Unimplemented
Figure 6-5. EE1DIV Divider High Register (EE1DIVH)
Address: $FE1B
Bit 7 6 5 4 3 2 1 Bit 0
Read:
EEDIV7 EEDIV6 EEDIV5 EEDIV4 EEDIV3 EEDIV2 EEDIV1 EEDIV0
Write:
Reset: Contents of EE1DIVLNVR ($FE11)
Figure 6-6. EE1DIV Divider Low Register (EE1DIVL)