Datasheet

System Integration Module (SIM)
MC68HC908GP32 Data Sheet, Rev. 10
170 Freescale Semiconductor
Figure 14-16 and Figure 14-17 show the timing for WAIT recovery.
Figure 14-16. Wait Recovery from Interrupt or Break
Figure 14-17. Wait Recovery from Internal Reset
14.6.2 Stop Mode
In stop mode, the SIM counter is reset and the system clocks are disabled. An interrupt request from a
module can cause an exit from stop mode. Stacking for interrupts begins after the selected stop recovery
time has elapsed. Reset or break also causes an exit from stop mode.
The SIM disables the clock generator module outputs (CGMOUT and CGMXCLK) in stop mode, stopping
the CPU and peripherals. Stop recovery time is selectable using the SSREC bit in the mask option
register (MOR). If SSREC is set, stop recovery is reduced from the normal delay of 4096 CGMXCLK
cycles down to 32. This is ideal for applications using canned oscillators that do not require long startup
times from stop mode.
NOTE
External crystal applications should use the full stop recovery time by
clearing the SSREC bit unless the OSCSTOPEN bit is set in CONFIG2.
$6E0C$6E0B $00FF $00FE $00FD $00FC
$A6 $A6 $01 $0B $6E$A6
IAB
IDB
EXITSTOPWAIT
Note: EXITSTOPWAIT = RST pin, CPU interrupt, or break interrupt
IAB
IDB
RST
$A6 $A6
$6E0B
RST VCT H RST VCT L
$A6
CGMXCLK
32
CYCLES
32
CYCLES