Datasheet

Interrupts
MC68HC908GR60A • MC68HC908GR48A • MC68HC908GR32A Data Sheet, Rev. 5
Freescale Semiconductor 251
Setting the channel x maximum duty cycle bit (CHxMAX) and setting the TOVx bit generates a 100% duty
cycle output. (See 18.8.4 TIM2 Channel Status and Control Registers.)
18.4 Interrupts
The following TIM2 sources can generate interrupt requests:
• TIM2 overflow flag (TOF) — The TOF bit is set when the TIM2 counter reaches the modulo value
programmed in the TIM2 counter modulo registers. The TIM2 overflow interrupt enable bit, TOIE,
enables TIM2 overflow interrupt requests. TOF and TOIE are in the TIM2 status and control
register.
• TIM2 channel flags (CH5F:CH0F) — The CHxF bit is set when an input capture or output compare
occurs on channel x. Channel x TIM2 CPU interrupt requests are controlled by the channel x
interrupt enable bit, CHxIE.
18.5 Low-Power Modes
The WAIT and STOP instructions put the MCU in low-power standby modes.
18.5.1 Wait Mode
The TIM2 remains active after the execution of a WAIT instruction. In wait mode, the TIM2 registers are
not accessible by the CPU. Any enabled CPU interrupt request from the TIM2 can bring the MCU out of
wait mode.
If TIM2 functions are not required during wait mode, reduce power consumption by stopping the TIM2
before executing the WAIT instruction.
18.5.2 Stop Mode
The TIM2 is inactive after the execution of a STOP instruction. The STOP instruction does not affect
register conditions or the state of the TIM2 counter. TIM2 operation resumes when the MCU exits stop
mode.
18.6 TIM2 During Break Interrupts
A break interrupt stops the TIM2 counter and inhibits input captures.
The system integration module (SIM) controls whether status bits in other modules can be cleared during
the break state. The BCFE bit in the SIM break flag control register (SBFCR) enables software to clear
status bits during the break state. (See 14.7.3 Break Flag Control Register.)
To allow software to clear status bits during a break interrupt, write a 1 to the BCFE bit. If a status bit is
cleared during the break state, it remains cleared when the MCU exits the break state.
To protect status bits during the break state, write a 0 to the BCFE bit. With BCFE at 0 (its default state),
software can read and write I/O registers during the break state without affecting status bits. Some status
bits have a 2-step read/write clearing procedure. If software does the first step on such a bit before the
break, the bit cannot change during the break state as long as BCFE is at 0. After the break, doing the
second step clears the status bit.