Datasheet

Enhanced Serial Communications Interface (ESCI) Module
MC68HC908GZ16 • MC68HC908GZ8 Data Sheet, Rev. 4
204 Freescale Semiconductor
15.8.6 ESCI Data Register
The ESCI data register (SCDR) is the buffer between the internal data bus and the receive and transmit
shift registers. Reset has no effect on data in the ESCI data register.
R7/T7:R0/T0 — Receive/Transmit Data Bits
Reading address $0018 accesses the read-only received data bits, R7:R0. Writing to address $0018
writes the data to be transmitted, T7:T0. Reset has no effect on the ESCI data register.
NOTE
Do not use read-modify-write instructions on the ESCI data register.
15.8.7 ESCI Baud Rate Register
The ESCI baud rate register (SCBR) together with the ESCI prescaler register selects the baud rate for
both the receiver and the transmitter.
NOTE
There are two prescalers available to adjust the baud rate. One in the ESCI
baud rate register and one in the ESCI prescaler register.
LINT — LIN Transmit Enable
This read/write bit selects the enhanced ESCI features for the local interconnect network (LIN) protocol
as shown in Table 15-6. Reset clears LINT.
LINR — LIN Receiver Bits
This read/write bit selects the enhanced ESCI features for the local interconnect network (LIN) protocol
as shown in Table 15-6. Reset clears LINR.
Address: $0018
Bit 7654321Bit 0
Read:R7R6R5R4R3R2R1R0
Write: T7 T6 T5 T4 T3 T2 T1 T0
Reset: Unaffected by reset
Figure 15-16. ESCI Data Register (SCDR)
Address: $0019
Bit 7654321Bit 0
Read:
LINT LINR SCP1 SCP0 R SCR2 SCR1 SCR0
Write:
Reset:00000000
R = Reserved
Figure 15-17. ESCI Baud Rate Register (SCBR)