Datasheet

I/O Registers
MC68HC908GZ60 • MC68HC908GZ48 • MC68HC908GZ32 Data Sheet, Rev. 6
Freescale Semiconductor 255
16.12 I/O Registers
Three registers control and monitor SPI operation:
• SPI control register (SPCR)
• SPI status and control register (SPSCR)
• SPI data register (SPDR)
16.12.1 SPI Control Register
The SPI control register:
• Enables SPI module interrupt requests
• Configures the SPI module as master or slave
• Selects serial clock polarity and phase
• Configures the SPSCK, MOSI, and MISO pins as open-drain outputs
• Enables the SPI module
SPRIE — SPI Receiver Interrupt Enable Bit
This read/write bit enables CPU interrupt requests generated by the SPRF bit. The SPRF bit is set
when a byte transfers from the shift register to the receive data register. Reset clears the SPRIE bit.
1 = SPRF CPU interrupt requests enabled
0 = SPRF CPU interrupt requests disabled
SPMSTR — SPI Master Bit
This read/write bit selects master mode operation or slave mode operation. Reset sets the SPMSTR
bit.
1 = Master mode
0 = Slave mode
Table 16-2. SPI Configuration
SPE SPMSTR MODFEN SPI Configuration Function of SS Pin
0
X
(1))
1. X = Don’t care
X Not enabled
General-purpose I/O;
SS
ignored by SPI
1 0 X Slave Input-only to SPI
1 1 0 Master without MODF
General-purpose I/O;
SS
ignored by SPI
1 1 1 Master with MODF Input-only to SPI
Address: $0010
Bit 7654321Bit 0
Read:
SPRIE R SPMSTR CPOL CPHA SPWOM SPE SPTIE
Write:
Reset:00101000
R
= Reserved
Figure 16-14. SPI Control Register (SPCR)