Datasheet

Input/Output Registers
MC68HC908GZ60 • MC68HC908GZ48 • MC68HC908GZ32 Data Sheet, Rev. 6
Freescale Semiconductor 275
MSxB — Mode Select Bit B
This read/write bit selects buffered output compare/PWM operation. MSxB exists only in the TIM1
channel 0 status and control register.
Setting MS0B disables the channel 1 status and control register and reverts T1CH1 to general-purpose
I/O.
Reset clears the MSxB bit.
1 = Buffered output compare/PWM operation enabled
0 = Buffered output compare/PWM operation disabled
MSxA — Mode Select Bit A
When ELSxB:A ≠ 00, this read/write bit selects either input capture operation or unbuffered output
compare/PWM operation. See Table 18-2.
1 = Unbuffered output compare/PWM operation
0 = Input capture operation
When ELSxB:A = 00, this read/write bit selects the initial output level of the TCHx pin (see Table 18-2).
Reset clears the MSxA bit.
1 = Initial output level low
0 = Initial output level high
NOTE
Before changing a channel function by writing to the MSxB or MSxA bit, set
the TSTOP and TRST bits in the TIM1 status and control register (T1SC).
ELSxB and ELSxA — Edge/Level Select Bits
When channel x is an input capture channel, these read/write bits control the active edge-sensing logic
on channel x.
When channel x is an output compare channel, ELSxB and ELSxA control the channel x output
behavior when an output compare occurs.
Table 18-2. Mode, Edge, and Level Selection
MSxB MSxA ELSxB ELSxA Mode Configuration
X0 0 0
Output preset
Pin under port control; initial output level high
X 1 0 0 Pin under port control; initial output level low
00 0 1
Input capture
Capture on rising edge only
0 0 1 0 Capture on falling edge only
0 0 1 1 Capture on rising or falling edge
01 0 0
Output compare
or PWM
Software compare only
0 1 0 1 Toggle output on compare
0 1 1 0 Clear output on compare
0 1 1 1 Set output on compare
1 X 0 1 Buffered
output
compare or
buffered PWM
Toggle output on compare
1 X 1 0 Clear output on compare
1 X 1 1 Set output on compare