Datasheet

Timer Interface Module (TIM)
I/O Registers
MC68HC908JB8•MC68HC08JB8•MC68HC08JT8 — Rev. 2.3 Technical Data
Freescale Semiconductor Timer Interface Module (TIM) 191
TSTOP — TIM Stop Bit
This read/write bit stops the TIM counter. Counting resumes when
TSTOP is cleared. Reset sets the TSTOP bit, stopping the TIM
counter until software clears the TSTOP bit.
1 = TIM counter stopped
0 = TIM counter active
NOTE: Do not set the TSTOP bit before entering wait mode if the TIM is required
to exit wait mode.
TRST — TIM Reset Bit
Setting this write-only bit resets the TIM counter and the TIM
prescaler. Setting TRST has no effect on any other registers.
Counting resumes from $0000. TRST is cleared automatically after
the TIM counter is reset and always reads as logic 0. Reset clears the
TRST bit.
1 = Prescaler and TIM counter cleared
0 = No effect
NOTE: Setting the TSTOP and TRST bits simultaneously stops the TIM counter
at a value of $0000.
PS[2:0] — Prescaler Select Bits
These read/write bits select either the PTE0/TCLK pin or one of the
seven prescaler outputs as the input to the TIM counter as
Table 11-2 shows. Reset clears the PS[2:0] bits.
Table 11-2. Prescaler Selection
PS2 PS1 PS0 TIM Clock Source
0 0 0 Internal Bus Clock ÷1
0 0 1 Internal Bus Clock ÷ 2
0 1 0 Internal Bus Clock ÷ 4
0 1 1 Internal Bus Clock ÷ 8
1 0 0 Internal Bus Clock ÷ 16
1 0 1 Internal Bus Clock ÷ 32
1 1 0 Internal Bus Clock ÷ 64
1 1 1 PTE0/TCLK